Our Family Truckster had dismal rear interior lighting so I decided to ramp it up with a single Baja Designs Dome Light. Check out the simple install and how freaking bright it is! Pick it up here amzn.to/3nTZOTe Please LIKE, SHARE and SUBSCRIBE if you haven't already Peace out!!!
@khanghua327410 ай бұрын
Great tip wiring it to the close button. Worked a charm. Nice and clean install without having to run a lot of wiring.
@RobDaman10 ай бұрын
Glad it helped
@dr.emilschaffhausen46833 жыл бұрын
Honestly, a bit of an oversight for Lexus for this vehicle which has so many awesome amenities already.
@Silverback_GMT4102 жыл бұрын
Great vid! I have a slightly different application but the reference helps!
@DrewDayToday3 жыл бұрын
nice those little dome lights/rock lights do put out some good light
@RobDaman3 жыл бұрын
#bringingthesun
@enzogaga8962 жыл бұрын
Awesome mod! I am doing it for my LX. Thanks for the great mods
@joyridaz3 жыл бұрын
Nice and impactful first mod! Maybe I missed it, but I wonder if there’s a way for it to automatically turn on when the hatch opens?
@RobDaman3 жыл бұрын
If you had a switchless LED or a toggle switch vs a push button like mine, it should ideally light up when open.
@josephchan70402 жыл бұрын
Does not work. Once the power is cut to it, it will turn off until the button is hit.
@abhiramrajesh4620 Жыл бұрын
Does it draw a lot of power from the batteries ? Like when the vehicle is switched off. Like if it’s used during camping
@Rob-pb8tp3 жыл бұрын
Nice Rob! Happy Wife, happy life! Great added safety aspect too for cross traffic at night. Since the light goes out when it closes, does it also come on when it opens?
@RobDaman3 жыл бұрын
It's more a momentary switch so it turns on but doesn't stay switched on when it sees a power disconnect
@MWDAdventures3 жыл бұрын
How hot does it get? From Baja designs website.Caution: Dome Light w/ Switch can get very hot when used for long periods of time. Please use caution when handling or installing.
@RobDaman3 жыл бұрын
Never noticed the heat issues but the body is aluminum for heat dissipation
@enzogaga8962 жыл бұрын
Hi Rob, any specific t-taps for this mod or any kinds would work? Thanks
@floydavila84063 жыл бұрын
nicely done. I have a 2011 LC200, would you know where to tap into power for a set up like yours? TIA
@RobDaman3 жыл бұрын
Should be same place as ours.
@bowagoner98773 жыл бұрын
Hi Rob i see you took the shell off the Tacoma.
@RobDaman3 жыл бұрын
The hard shell? It's been off since SEMA
@marcryan273 жыл бұрын
Hey Rob, what is that thing you used to tap i to the wires?
@RobDaman3 жыл бұрын
Initially I was going to use posi tap but I didn't have the smallest gauge (red) amzn.to/3w2A5w1 So I went with traditional scotch locks amzn.to/3d9Y2J0
@TNSlaytanic3 жыл бұрын
I have a 2011 LX570 with powered lift gate and I could not get it to work. I do not get any V to the larger red wire and 2V to the smaller red wire. Connect LED straight to battery and it works. ideas?
@RobDaman3 жыл бұрын
does the button close your hatch?
@TNSlaytanic3 жыл бұрын
@@RobDaman yes, everything works; dash button, remote, back handle
@RobDaman3 жыл бұрын
That insulation is pretty thick so perhaps test your contact again.