Alpine ski waxing and edge grinding - basic preparation (ski care tutorial)

[@chadridsdale9970]

No narration or description?

[@BabbaBoom]

Schleift man nicht in die laufrichtung?

[@drewblack3686]

exactly, does he know what he is doing, even the iron is not used correctly, why does it have an sloping edge on one side

[@wisecoonie]

Mît der Basefile ist das ja unmöglich. Und das Feilen soll nicht unbedingt von Tip to Tail gemacht werden, so lange man nach dem Feilen die Kante ganz sauber aufpoliert mit der Diamantfeile.

[@Kuper133]

М-да,это ж надо с одной лыжей три часа возиться. Что их надрючивать. Канты точнул,запарафинил и кататься. У меня вся семья катает и на мне подготовка две пары лыж и сноуборд. Я б таким способом до второго пришествия бы возился..😊

[@Летодлядетей]

Каждый раз это делать снимая крепления? Во что превратятся лыжи?

[@Котэ-ы9щ]

Это показательное видео на новой лыже. Крепеж снимать не обязательно. Но если очень хочется - никто не запрещает!

[@Kuper133]

И что им будет если снимать крепления? Я всегда снимаю.

[@danibuhlmann4001]

Keine Diamantfeile?

[@michaelkerr1755]

Don't file your base edge 😮 just diamond lightly you'll be base high in about two tunes if you file every time.

[@drewblack3686]

some of the worst pre I have ever seen, against the direction of file and does he know how the iron should be used

[@wisecoonie]

You just can’t use a basefile from tip to tail for both edges. Have you tried this yet?

[@Slears]

Was für eine Wachsverschwendung...unglaublich...mit der Menge Wachs kannst 4 paar Ski wachsen...

[@wisecoonie]

Stimmt. Warum wird der Tip gewachst? Blödsinn.

[@86yutaka]

ｗａｘ使いすぎ（笑）！ 滑走面が焦げるから何度もアイロンを当てるなと教えられていましたが、アイロンを動かすのを止めなければｏｋなんですね。

[@PetrChytil-u2n]

Zu viel Wachs

[@Infinity2219]

Don't remove as much wax as he did or bronze brush as you will need to come back sooner. I'm a engineer and see how capitalism has crept into this video 😢

[@FabianPircher-g7j]

yes if you let some wax on the ski it will hold longer but if you get out everything it’s faster

[@skiprofessor5328]

I actually perform this for 20 years today and must say you take to much edge metal and you are putting to much pressure on them as well (side edge) this is unnecessary to be honest and could be replaced with one way straight Push - twice if needed and then blue diamond twice and polish like this with red - no need to take them so much- otherwise you are getting closer to the sidewall and in few momenents you will need to extend the side wall edge to the level the edge will have full contact- sorry for the comment but I cannot agree