2018-2019 Mustang GT & EcoBoost RTR Bumper Vents Review & Install

[@americanmuscle]

Shop These RTR Bumper Vents: muscle.am/2DhlDqO Subscribe For Daily New Mustang Videos: muscle.am/SubscribeAMyt

[@saddle8bag]

I'm not seeing the path for this airflow to the brakes. I barely see an opening either way and then whatever air does manage to get thru looks like it'll be blocked by the wheel well cover.

[@kendariuspresswood4766]

I wouldn’t do all of this just for some vents. If I was installing something big that requires me to remove the bumper and I had the vents at the time I’d do it all at once. There’s no proof that they work so I don’t know about this one.

[@whpony96]

I'm Curious, how exactly are these going to help cool the engine bay? Could you please show me the wind tunnel tests? Also show me some before, and after install temps.

[@vzombie]

You guys make it look so easy, I’ve been trying for 3 hours trying to take them off and nothing… hands and fingers hurt so I had to stop… it does not come off as easy as you guys are making it seem, I used pry tools and screw driver and nothing

[@Sky-fb4rx]

Did you end up figuring it out?…coz I couldn’t

[@vzombie]

@@Sky-fb4rx yes I did, kinda difficult at first, but once installed they look so good… I still haven’t swapped out my bumper to my OEM(with RTR lights)

[@Sky-fb4rx]

@@vzombie what’s the trick? I tried pulling the tabs down and still wouldn’t work

[@vzombie]

@@Sky-fb4rx honestly, just keep pulling the tabs until they pull apart.

[@TheCdM1981]

but did you change the fender liner that works with these on a PP1 or PP2 because the bumper vents are closed on those completely.

[@shea5287]

Is the vein (however it's spelled) required to complete the installation or can the RTR vent just replace the factory one?

[@jimthornton5109]

Nasty ! getting the factory vents out is extremely! ! Difficult !! to remove when I say extremely difficult to remove that is an understatement

[@ghostryder1829]

Id like to know if there are any type of accent lighting sorta like the demon eyes that is made to go where the factory bumper vents are? If not id like to see a manufacturer create some for the S550.

[@TheCdM1981]

The vents weren’t designed to go into the brakes. It was to cool the engine and the vains run air to the outside of the wheels.

[@jeremy2606]

Lol I had no clue they revised the bumper clips on the 18+ I've been scared to take my bumper off the whole time.😅😅

[@popeye5808]

Will these fit my 2005 mustang?

[@91302lx]

Maaannn where the Cobra at?

[@Sumodf]

I dont think they do anything, but do look clean on car.

[@Joeindahouse98]

He’s a KZbinr

[@Joeindahouse98]

You look like dan mace

[@jimthornton5109]

Too much work to remove original “ vent “ , cost too much and you get no real performance improvement

[@robmccance]

What total overpriced, nonperforming garbage. And you have to remove the front bumper to boot. RTR should be embarrassed. Seriously.