lesson 10 1 CFD of Boat in Ansys Workbench Fluent

[@FoteiniDianou]

Hello, could you tell me why did you decide to have such a small domain and especially a small distance between the inlet and the boat? I'm new to marine cfd and I would like to know if that is a standard procedure.

[@thepacifier3267]

Is there a contact between the air and water domain? How did you separate them? Dont you have to use VOF model?

[@mehmetdelikan4687]

Thank you for thi useful tutorial. Can you make a tutorial for calculating wave resistance ?

[@Halyconist]

Thanks a lot

[@ridwantician]

Please I can't find the part 2 of this tutorial on you channel

[@premnaik4752]

Hello sir, i am working on a sailboat project. I have done simulations. how to check weather my results( typical values) are correct or not? and also how change wind direction?

[@시아주니]

Can you make a tutorial for calculating wave resistance ? pls ㅜㅜ

[@hanaadr8960]

Hello sir, I am doing a graduation project for a numerical simulation of ship wake I got the results but I want to make the wake shaft behind the ship So I want to design a circular plane in the Ansys fluent This thesis is obtained in the absence of the propeller Knowing that the domain of calcul is a box not cylindrical

[@Bharathacad]

Use open channel wave setup

[@robinmichael3169]

@@Bharathacad how can i get the green water on deck simulation and measurement on this sir?

[@Bharathacad]

@@robinmichael3169 not green water that is contour result

[@ryanlucht6625]

Im getting this error "Warning: zone of type interior found between different fluids! Material of cell zone 5 is water-liquid, while material of cell zone 6 is air." floating point exception upon trying to solve I tried defining the slice (face between air and water region) as a wall but that didnt help. Do you know what's wrong? Im also not using the geometry you made here, Im using a solidworks file i imported as an iges. Everything else is same

[@Bharathacad]

it is step file and u need split the geometry on Designer moduler

[@raghavab5584]

excellent sir, we can do moving for this example?

[@Bharathacad]

Not this software, it can be done in ansys discovery

[@trololollolololololl]

@@Bharathacad can u easily put solution from workbench to discovery?

[@meesamshah9291]

Following

[@umarlatif1603]

you moved the boat up, wtf. Why not multiphase simulation and let air interact with water