Ansys Fluent Tutorial for Beginners | Axisymmetric swirl | Labyrinth seal

Can you write me a review?: g.page/r/CdbyG...
/ mech-tech-simulations
/ mech.tech.simulations
/ mechtechsimulations
mechtechsimula...
WhatsApp: [phone]
Ansys tutorial in Workbench. This video explains how to simulate Labyrinth Seal with a simple seal in terms of leakage. A comparison of results is made between them.

[@Denim007]

Looks good. Good idea. Yet, when I see the mesh I am wondering if the velocity profile is fully captured.In that matter I would follow the y_plus value close to the wall. But overall, good showcase.

[@MrRaminhodinho]

This is amazing work. I will try to follow the steps and do it all over by myself. but thank you again for this awesome video

[@MechTechSimulations]

You're so welcome!

[@MrRaminhodinho]

at 9:00 min how did you get to that step please

[@laurirauhala6052]

Thanks for this good tutorial. One question: how can mass flow be calculated accurately from only a 2D model? If axle diameter grows, also the cross-sectional area of the leakage grows and shouldn't that be taken into account? Can this model be made also in 3D?

[@MechTechSimulations]

It can be modelled as 2D axisymmetric so that, the influence of the diameter will be computed according to the polar coordinates. It's also possible to model this in 3D.

[@yariiijan8225]

Is Ryzen 5 4600H with Nvidia Gtx 1650 good for Ansys, Solidworks, Openform, Hypermesh, Ansa? Any problem in that? Reply fast

[@ismailrubel3163]

Nice 👍it's help me lot. How to make a correlation between Intel swirl ratio and cross-coupled stiffness & damping stiffness ?For example inlet swirl increasing than what is the behaviour of cross-coupled stiffness & damping . Is it possible ?

[@energyengineer5266]

Please make a video on Swirl Flow in a beaker having water in the beaker with a magnetic stirrer. First without any hindrance in the beaker, then with hindrances in the beaker (like semi-circular, triangular, and rectangular hindrance). Thanks.

[@KING.BABAR.AZAM.5631]

Hi.sir how to make screw compressor roter step by step 3*5 or 4*5