Ansys modeling setup for air-cooled battery array

[@박수완-w7f]

Hello. I am studying battery cell cooling using Ansys Fluent. I was able to check the contours similar to yours by giving the variable value in your video to my geometry file. However, since I use Samsung SDI's INR21700 cell, I have to enter a different value from the value you gave me in the video. So I calculated the input value while looking at the battery specification you used. What I don't understand is, did you enter a value of 16800 in Cell Zone Condits>Solid>Source Terms>Energy Source? Because for the cell you used, the energy source should be 530,421Wh/m^3 because E=2.5Ah*3.6V=9Wh and V=1.6965*10^(-5)m3. I didn't understand the association between this value and the value you entered, 16,800W/m^3. Can I ask you to explain this please?

[@saikolamrangolisshorts8545]

I need to enable battery model for cylindrical battery simulation, if i enble battery model means what are the steps i need to follow

[@김회성-o5i]

Could you please send me geometry and mesh file, appreciate it.

[@OmarSukkar]

hello, the mesh part wasn't very clear is possible to show the steps.

[@amysstore4167]

I want the geometry and mesh file , can you please send it to me

[@nathanielmark5059]

Could i get the mesh and geometry file please?

[@viethung5253]

Please send me geometry and mesh file. Many thanks

[@mdsaad3048]

Please send geometry and mesh file

[@amysstore4167]

I want them also , can you please send it to me