ArcDroid: Cut Clip. High speed cut on cold rolled steel.

[@TripodsGarage]

Nicely done! I see that you are using THC. When will it be available for everyone? I finally got my unboxed after almost a year (long story electrical in my garage needed to be upgraded). I have been posting on my Twitter, Facebook and Instagram. Would be nice to have THC functional on mine.

[@amp_mechanic]

No clue but if you email ArcDroid with your serial number they will give you your unlock code and instructions. It's a bit of a battle to make it work. If their instructions don't work for you, go watch both my videos on THC, I list my settings and proper range for your divided voltage.

[@TripodsGarage]

@@amp_mechanic I did the firmware before I even turned it on for the first time. I saw that it had THC button, clicked on it, then was greeted with the email instructions. I haven't seen anything on their forums, or videos about setting up THC by the manufacture. Seeing that THC is being used in this video, and it is shown a lot. It was my hope that they worked out the bugs with THC and will provide details on what it takes to set it up. I will defiantly check out your videos! Thanks. Side note, does your Z axis make a bit more noise than the X and Y? I am used to 3D printers and lasers engravers that do not make nearly as much noise on the Z.

[@davidcat1455]

Can either of you gentlemen tell me the correct shutdown procedure for my arc droid? Being almost totally computer illiterate means I spend a lot of time trying to make it work 😃. Not very successfully. I’ll figure it out eventually but in the meantime every time I go to turn it off I am worried that I am doing damage. So far I’ve just been hitting the power button and walking away out of desperation. Or am I worrying about nothing? nowhere in the instructions or on any of the videos that I’ve seen is there an actual shut down procedure.

[@TripodsGarage]

@@davidcat1455 - Hello, I have been in the 3D Printing space for over three years (Tripods Garage is my KZbin Channel). The ArcDroid is running a Fork of Marlin, Marlin is what a lot of 3D Printers use for operation. All 3D Printers that I own and or used that run Marlin do not have a power down sequence. You just turn it off. Hope that answers your question.

[@davidcat1455]

@@TripodsGarage Thanks.

[@davidcat1455]

Good job😃👍🇺🇦🇦🇺🇺🇸

[@amp_mechanic]

Thanks David