Assembling a 4WD Robot with Arduino (Elecrow Part 2)

Starting to put together a little robot car using Elecrow's Crowtail educational kit!
The previous video was exploring the kit, and the next one will be programming it 😁
❤ DON'T FORGET TO LIKE AND SUBSCRIBE! ❤
🔥 Don't forget to check out Elecrow's products🔥
- Part 1: kzbin.info/www/bejne/i3LJXntunsSZl68
- Crowtail Deluxe Kit for Arduino: plati.ma/go/crowtail-deluxe
- Crowtail 4WD 'Dorado' Kit: plati.ma/go/elecrow-dorado
- Kaiweets Electric Screwdriver: www.aliexpress.com/item/1005005236861571.html
🛒 Shop: shop.plati.ma
💵 PayPal: paypal.me/PlatimaCash
📺 Other Channel: youtube.com/@platima
📷 Instagram: platimatinkers
🌏 Reddit: reddit.com/u/platimazero
💳 Patreon: patreon.com/platima
Exit the Premises by Kevin MacLeod incompetech.com
Creative Commons - Attribution 4.0 International - CC BY 4.0
#Platima #Elecrow

[@jyvben1520]

Was thinking if the wires are long enough to mount all the electronics hanging of the top plate, keep the top of the bottom plate to store the batteries (protection from impact), a 20 wire ribbon cable between the 2 plates might be better, anyway a lot of options, but not for a 2 wheel balancing. Does the kit have a charging circuit for the batteries ?

[@PlatimaTinkers]

That is a VERY good idea re the 'suspension' and impact prevention. I'm going to do that wiring off-cam I think, cause even this 15 min video was actually 2-3 hours work haha. No charging circuit as far as I can see, but I do have a few TP4056 modules I might integrate with a DW01A if I have any left!

[@DaxSudo]

Cmon kids gotta learn how to cuss at some point. Who better than an Australian engineer?

[@jyvben1520]

they will learn and then they have to learn when not to cuss ...

[@PlatimaTinkers]

Hahah yes yes ,but I try to be responsible sometimes! Plus as mentioned these videos do not get many views, so to support Elecrow I figure dropping the language helps

[@PlatimaTinkers]

@@jyvben1520 Hrmm, valid point. Bit of a scourge these days hey?