AtomRC Dolphin 6S - Part three

[@terrymurphy562]

Well done Caroline, top job, gonna be nice.

[@Caroline_Tyler]

I'm looking forward to finishing it!

[@CliffHarveyRCPlanes]

That seems a lot of electronics Caroline but when you break it down the way you do it all makes sense 👍

[@Caroline_Tyler]

It's all about the planning and dry fitting before you stick anything down. Like making anything, measure twice, cut once.

[@Drone.vision]

Brilliant that , it’s a great talent to have building those , well Done 🙂👏

[@Caroline_Tyler]

Thanks, part 4 tomorrow should finish the physical build, part 5 I'll go over the INAV setup.

[@Drone.vision]

@ brill I will make sure to catch that one too 🙂

[@CurryKitten]

coming along nicely

[@Caroline_Tyler]

Thanks, I'm being a bit slow on the build as work and life has got in the way a little.

[@DadsRCHangar]

Very pro build Caroline. 👍🏻

[@Caroline_Tyler]

Anyone would think I knew what I was doing? 😂😂

[@DadsRCHangar]

@ You are clever and know your stuff 😁

[@Darren.n.RCvids]

Great video, Not too sure how you have wired up the other end of the cable from the 03 unit to the flight controller.

[@Caroline_Tyler]

I'll do a diagram and put it on the Community section for you

[@Darren.n.RCvids]

@Caroline_Tyler thank you Caroline.

[@FixedWing]

Those 4 wire cables for the RX are always a pain for me as I typically want to use servo cable. Recently started removing a couple of pairs from an ethernet cable which work OK but the colors are a bit dodgy. Mind sharing what cable you use for your 4 wire connectors?

[@Caroline_Tyler]

I'll put in all the details in the next video - releasing on Sunday.