Atomstack P9 M40 Laser Engraver | Unboxing | Setup | Review

[@PLIDD]

Great review How much power it needs to run? can it run on RV battery?

[@CASSDesigns]

It has the capability to draw up to 40 Watts, im not sure if it can run off of an RV battery, to be honest I’m not very electrically inclined

[@davidnyeste7282]

Great video, I've been looking at laser engravers for my workshop. I wonder how well it would work with kydex

[@paulmayuk]

Hi and great video. I’m completely new to this and I’m looking to get one of these machines in the near future. Can you tell me have you produced a video that covers the initial setup for a first engrave e.g. positioning of item to be engraved, how to set the start point for the laser etc. fingers crossed.

[@CASSDesigns]

I have not (sorry for the late reply), but the software you use could vary depending on what software it is. There are a lot of software tutorials for engravers but not on my channel at this time

[@bichymafsh2606]

Hola buenas noches. Tienes vifeos donde cortas y grabas acrílico?

[@CASSDesigns]

¡ey! Yo no, pero cortó el acrílico negro muy fácilmente. El acrílico transparente es más desafiante para un grabador de baja potencia como este. Lo siento si esto es un poco inexacto, estoy usando un traductor.

[@bichymafsh2606]

@@CASSDesigns ok entiendo, como consigo ese tipo de acrílico? Gracias

[@febreeze2_338]

Great video

[@ThePowerknoedel]

you make great videos and great project´s. Please upgrade your Microphone it does not sound that great. But please go on making great videos!

[@CASSDesigns]

Thanks! I’ll play around with my settings and test some things out