Attaching Ripplefold Snap Tape to R-Trac system

See how to attach snap tape to R-Trac hardware for ripplefold style panels including adjustments taken for overlaps and returns.

[@rowleycompany1]

For a Ripplefold drapery panel, turn under a 1" header, lay the tape down 1/8" from the top and sew on both sides of the snaps, completing two stitch lines the entire width of the panel, covering the raw edge of the face fabric. It’s best to use a skinny foot or a zipper foot to sew on the tape so the foot doesn't interfere with the snaps. Check out the recorded webinar “Clean & Contemporary Ripplefold Panels” on our website for full instructions on making the panel and installing the tracks.

[@DDFiretree]

You are such a smart woman! They never listen, the workroom sews the drapes before the tracks arrive!!! Argh!

[@kathleenhoward5844]

Would you have any videos on how to make template for ceiling with a slant?I am making ripplefold curtains with the header being on a slant

[@Cazenrique44]

how to sew the fabric on the tape, what kind of foot? ... to SNAP it is just common sense. I called you guys before enquiring about some technical information, was told that someone would call me back and that was 6 months ago, and I'm a known manufacturer.

[@meljimfreya]

I am struggling to attach the snaps to the rings. Its incredibly difficult. Far to hard to snap with ordinary fingers pressure. Dissappointing can't get my curtains up this arvo

[@garnorix]

I call BS. the snaps are never that simple and you have to nearly break your fingers to get the pendants attached to the drapery. you guys need to make a tool for connecting them