You're doing God's work...currently out of town, boss abandoned me and said good luck. Thanks to you I can have some semblance of hope.
@kehuang14522 жыл бұрын
Thank you so much, this is so much clearer than the manual
@jlmmyn3utron Жыл бұрын
So once it has completed setup, what is a considered a "normal" display on the outside unit LCD? Mine scrolls through the addresses over and over again, but seems to be working fine. The only concern I have is that the target temp is often overshot in one room when the other two larger rooms are still running.
@kiskokisko2 жыл бұрын
I'm having a communication error with one indoor unit and the fjm here. Is there a way to re address the system like on startup? I checked the continuity of the wires and receimped the termination but still getting the error.
@kingsherman692 ай бұрын
Should i turn the indoor units ON before i do the auto pairing?
@Randalllac Жыл бұрын
Do you have a suggestion if the k1 button doesn't do anything
@rsbozworth834 Жыл бұрын
We are having a problem with the modbus cards and getting the outdoor units to talk to our BMS system
@billpaxton88625 ай бұрын
I Started a pipe check with no refrigerant in the lines, would that mess up the compressor or anything? Getting a pipe check error code . Did a reset of outdoor unit. Checked pipes, found one minor kink that I rounded out. Still getting error code
@NotOurRemedy22 күн бұрын
Definitely have it vacuumed and charged due
@Abrokadabro2 жыл бұрын
So much better than Samsung tech support
@juliocesarfernandez48489 ай бұрын
Hola amigos , debo agregar una unidad evaporadora al sistema , cómo es el procedimiento!
@champbennett294 Жыл бұрын
How long does K1 take to kick
@marcosfisgadabruta5408 Жыл бұрын
To tentando configurar o meu mais a Seg maquina não daí o f2
@christ6195Ай бұрын
You have saved me, the instructions are junk, many thanks 🎉
@hamidkordi13562 жыл бұрын
Thank you top top
@lawrencemutaleiii45303 жыл бұрын
Hello.. I have a challenge with One FJM system with 3 indoor units one of the units doesn't heat effectively and at some point cuts the fan [during heating mode]
@foxstf44313 жыл бұрын
What model is your s? On cool mode with all 3 indoor unit on what is the max frequency of te compressor! Thanks
@Pau1ys3 жыл бұрын
what did you find out the issue was causing this?
@adelinochimbungule Жыл бұрын
Quantas unidades Evaporador
@gothandaraj860 Жыл бұрын
Samsung vrf ac how to set auto address and test mode
@AkhlakhShaikh-on9pv9 ай бұрын
2 time k2 presh
@bghen40067 ай бұрын
Solution E2 02?
@exlost24510 ай бұрын
My Samsung is showing U.P blinking. Dont know what that means
@adgonz67143 ай бұрын
idk what it means but it pisses me off
@loganjames5940 Жыл бұрын
My unit got to that section at 1:32 but it displayed the T1oT and didn’t switch to flash the addresses. Any help?
@Transformaster8 ай бұрын
It happened for me as well. I just pushed the k1 button again and it started doing it.