Back to Back 90's - Simple Conduit Bending

[@sethemersondavis3145]

Best video on KZbin of this subject thanks for making it

[@ethanbilovol9098]

Thanks for the help

[@rafaelbrea6743]

Perfect 👍

[@edmaloney9755]

For your first mark leave the ruler hang off five inches than mark 12. No math involved

[@fitnessfanatics9644]

Very informative. Thx.

[@Penguin545]

@4:16- geeze imagine slipping backwards and landing on that 90 😝

[@JackElectrician]

Thanks for the video!!!!

[@MCConstructionTeacher]

Thanks for watching!

[@vuitry4369]

"electrician turned plumber" lol!!! Really helpful video, thanks!!

[@MCConstructionTeacher]

I am happy some caught that haha

[@johnjohnsonstein8409]

With the star method, I was taught you keep the bender the same way

[@lawmat93]

Great content bro keep it up fellow sparky bored on KZbin lol

[@robertboyd4656]

Everyone leaves out measurements from center of pipe to 90% on each end so sad it's just quick math then the stubs dont matter just the back to back 90% matters as long as the pipe is the right length of what one needs way simpler just saying easy to cut you're total first with a straight pipe then one with a bend in it :)

[@smiththomas64]

Alingning the star to the line is tough

[@Penguin545]

You’ll find that if you look at the star from the top staring down at the ground at lines up much more naturally

[@zhumusic-ng9tr]

What about gain?

[@419chris419]

he said don't worry about it in the video if you're using the star.