bad news and good news antenna and antenna main mount is ok.

[@Dallas-Rife-UDX-347-Tennessee]

I’ll see if Mike has your info and I’ll get in touch with you in a couple days 👍

[@foxman362]

I had it less then 1ft in there down where 10ft antenna mount i keep cranking on boat winch it keep bending you can see in the video i starting cut off bad end where rope is at i put around 38ft from ​​beam to where i cut off bend bad end at i would put side 5ft inside 10ft antenna mount it come to 33ft the hard part is drilling 3 holes on same 10ft antenna mount i would have take off rca rotor after ​​ cut bad bend end hacksaw put 3 clamps on 10ft antenna mount where same pipe is at i would take rca rotor off leave off on siro sy27 s4 put on the ground then drill 3 holes on same hole antenna mount ​​with same pipe like did back Oct 12.

[@StandingStones1776-vb6zn]

Foxman make sure one pipe fits inside the other to the point its one and wont bend. how far in was it?

[@foxman362]

it was less then 1ft.

[@StandingStones1776-vb6zn]

@@foxman362 may need 2 foot ask around

[@foxman362]

@@StandingStones1776-vb6zn i was thinking putting 5ft inside 10ft antenna mount pipe it put me at 33ft.

[@foxman362]

@@StandingStones1776-vb6zn the pipes are from lowes in 11 area

[@Foxman362worldradio]

I just uploaded another video.

[@Dallas-Rife-UDX-347-Tennessee]

Maybe need two hitch points so it doesn’t buckle

[@UDX4570PalmSprings-yh1mv]

Seamless steam pipe !!!

[@foxman362]

the pipes are from lowes in 11 area

[@foxman362]

@@UDX4570PalmSprings-yh1mv the pipes are from lowes in 11 area.

[@UDX4570PalmSprings-yh1mv]

@@foxman362 Look in the phone book for someone who dismantles manufacturing plants for scrap you can probably find someone who would give you some seamless steam pipe for Penny's a pound, that shit is friggin bullet proof.

[@foxman362]

i think had weight and factor today what happen i didn't know this so i have put pipe 5ft inside 10ft antenna mount drill 3 holes was at like before. i think it should hold weight from bending pipe when lifts up i start hacksaw bad bend end of pipe. today i'm try cut off bad end where bends then i take bad bend pipe out.

[@codyjackson57]

Good luck brother, udx358😢

[@foxman362]

i'm try it again i know what have to do i had thought about today try rethink i think it's going work this time what wrote in the comments i'm doing this by myself.

[@craigw9cfw363]

Foxman, that really sucks. Are you using gas or water pipe?

[@Foxman362worldradio]

@@craigw9cfw363 its emt pipe you get at Lowe's in 11 area you'll see it on there site it not fence pipe.

[@craigw9cfw363]

@@Foxman362worldradio got ya. I had used black pipe which was for gas from Menards, which is like a Lowe’s. Unfortunately I found out that it bends really easily in high winds. I went to a specialty store to pick up water pipe, that pipe will not bend. Just a thought. I can’t wait to see the project completed ✔️