Basic Cisco ACI cli commands map to GUI - part2

00:15 - Show run leaf "nodeid"
01:00 - show run template port-channel "vpc_pol-grp"
01:30 - check port-channel settings i GUI.
02:55 - fabric "node id" show interface desc
04:18 - check descriptions for vpc in GUI
05:19 - show tenant "tenant name" application "ap" endpoints
07:13 - Check endpoints in GUI
08:00 - show endpoints mac "MAC"
08:38 - endpoint search in GUI
09:36 - show tenant "tenant name" detail
10:40 - show tenant "tenant name" epg "epgname" details
11:10 - check tenant information in GUI
12:05 - fabric "node id" show port-channel database
13:00 - fabric "node id" show port-channel summary
13:30 - fabric "node id" show mac address-table interface port-channel "po nr"
14:00 - Mapping VLAN to EPG.

[@skyscraperman99]

Very informative video Magnus.

[@MagnusHolmberg-NetSec]

your welcome :)

[@marutigawade7546]

Very informative

[@rizwanrashid172]

Bravo!

[@MagnusHolmberg-NetSec]

Thanks :)

[@sameerkashikar8224]

Awesome video

[@MagnusHolmberg-NetSec]

Thank you!

[@raghubanshtiwari1654]

Its awesome, can you please share some debug commands output for source and destination?

[@MagnusHolmberg-NetSec]

Thanks for watching :) We actually only use L2 within ACI so we are not able to do any debug on source/dest. All our L3 is done in routers or firewalls.

[@raghubanshtiwari1654]

@@MagnusHolmberg-NetSec Got it, thanks a lot for sharing such commands and I am also looking forward few more troubleshooting commands...👍

[@MagnusHolmberg-NetSec]

Raghubansh Tiwari am getting a brand new pod deliverd in a few weeks so maybe can show some layer 3 stuff then :)