Tap to unmute

"Battery is Damaged" message on my Autel Evo

  Рет қаралды 1,056

The Ukrainian

The Ukrainian

Күн бұрын

Пікірлер: 11
@moodberry
@moodberry 3 жыл бұрын
Your channel is fast becoming one of my favorites because I have two Evos and almost no one talks about the Evo 1 anymore. The Evo 1 is perhaps the best balance in features, performance, and price. But like I said in another comment, the key to making the Evo 1 have a long life is the batteries. If someone can figure out how to rebuild them I think a lot of money can be earned. I have subscribed and am anxious to see part 2. Thanks.
@the_ukrainian
@the_ukrainian 3 жыл бұрын
I have a guy. Will be one of the upcoming videos 😎
@rbromm4009
@rbromm4009 3 жыл бұрын
Have experienced several bad batteries. 2 almost simultaneously. Not software or firmware related in my case. Both batteries had about 40 cycles and a little over 2 yrs old. Treated them well too. New batteries work fine and hope they will continue to be available for awhile longer.
@702solidink
@702solidink 3 жыл бұрын
I have the same problem. How can I fix it ? Thank you
@the_ukrainian
@the_ukrainian 3 жыл бұрын
Working in it
@ua9851
@ua9851 3 жыл бұрын
Quite typical issue on Dji Mavic Pro batteries after off-season storage. As soon as one of the cells has more then 150mV deviation from anothers, it throws an error and motors could not be started. Such an issue could be fixed by manual cells balancing.
@kayberry6292
@kayberry6292 2 жыл бұрын
This worked for me on 3 batteries which reported damaged… I put each battery on the drone, turn on the drone and let the battery discharge until the drone shuts off. Then put the battery on the charger until the battery shuts off at full charge. Then put it back on the charger hours later (after it cools) until full charge. Then contrary to Autel's instruction, I put the battery back on the charger and hold the battery button for about 30 seconds then let it go. Autel says to hold the button 30 seconds while NOT connected to the charger and then connect it. The method of keeping it connected while doing the reset seems to be the trick to force the BMS to balance charge all the cells. I've had to do all these steps at least twice for each battery, discharge on the drone, fully charge, reset while on charger to balance charge. Then I test them on the drone while connected to the controller and the phone app to see the balance of the cells. I also had success in one instance simply by leaving a damaged battery connected to the charger for 2-3 days.
@lightdrone1117
@lightdrone1117 3 жыл бұрын
Не волнуйся, профиксим
@cicottino
@cicottino 3 жыл бұрын
but did you take them used?
@the_ukrainian
@the_ukrainian 3 жыл бұрын
yes, unfortunately
AUTEL EVO 2 PRO - AFTER CRASH RESULTS, QUADS FAULT & AUTEL WARRANTY IS SOLID
22:53
Autel Evo 1 Drone Battery Failure Damaged Battery (WTF)
10:45
Gambleman
Рет қаралды 1,1 М.
She wanted to set me up #shorts by Tsuriki Show
0:56
Tsuriki Show
Рет қаралды 8 МЛН
EVO Battery Charging Hub Walkthrough (Autel Robotics)
3:46
Autel Robotics
Рет қаралды 8 М.
Manually Updating Firmware
3:51
Autel Robotics
Рет қаралды 27 М.
Why DJI Drone Batteries Fail | Crucial Care & Maintenance
14:18
Steel City Drones
Рет қаралды 19 М.
Autel Evo Battery destroyed! DO NOT ATTEMPT!!!
13:11
The Ukrainian
Рет қаралды 667
Autel EVO Nano+ Range Test and Recovery
20:45
Circling the Drone
Рет қаралды 6 М.
The Autel EVO II’s Biggest Problem
7:59
Billy Kyle
Рет қаралды 46 М.
Drone Programming With Python Course | 3 Hours | Including x4 Projects | Computer Vision
3:33:03
Murtaza's Workshop - Robotics and AI
Рет қаралды 6 МЛН
Autel Battery Life
3:54
Pandion Flight
Рет қаралды 758