We are training new operators how to run the saw in the most efficient manner.
Пікірлер: 11
@josephf5934 ай бұрын
Piedmont plastics, I recognize that green set anywhere.
@kennethkustren93815 жыл бұрын
I worked the old version for 5yrs. DECORBOND Particleboard.... methinks about 90 lbs/sheet. Tough job, requiring inspection of finish on both sides, prior to loading. EPIC2 was the programming then. I am a dinosaur.
@SeosamhMacUaid Жыл бұрын
brillant stuff, thanks for sharing this, what is it that you are making?
@aslamkhan703911 ай бұрын
Please provide me all detail and specifications of beam saw machine .
@ryanchallis6293 Жыл бұрын
No need to hammer the boards straight just trim the back edge
@thomasprestoniii4903 Жыл бұрын
It’s good practice for 2 reasons. Grained directional material and plastic industry utilizes about 90% nominal cutting sizes for minimum drop, so sometimes there is no more than a dusting off the front and back.
@jocresdoesmix Жыл бұрын
Dont hammer the flywood it cause missalignment the reference guide or the clamping.
@thomasprestoniii4903 Жыл бұрын
The Pusher will adjust to proper cut position after it clamps. It has dual encoder measuring system and always knows where it is.
@gorsanimpaxwoodworkingmach147711 ай бұрын
Hii sir
@comedyrider4326 Жыл бұрын
Please give full information video about this software 🙏🙏
@thomasprestoniii4903 Жыл бұрын
Send me your email as a private message. I’ll send you 15 training videos I made for this particular software and machine.