It’s hard to hold the calipers perfectly straight, and any slight angle deviation will make it read slightly thicker.
@PawPawsWorkShop7 ай бұрын
That is very true. Are you also saying that the material cannot vary in thickness by several thousandths?
@TerrapinCreations6667 ай бұрын
@@PawPawsWorkShop Oh I’m sure it definitely can vary as well.
@charlesreicks6487 ай бұрын
Will your CNC allow you to do a finish pass, removing tool marks? Good demo Thanks Tim
@PawPawsWorkShop7 ай бұрын
Yes, I should have done that. Thanks for the reminder
@SNIPER837207 ай бұрын
GOOD JOB 👍
@PawPawsWorkShop7 ай бұрын
Thanks! I’m amazed at how easy it is to do the prism letters
@LYTOMIZE_Woodshop7 ай бұрын
I'm going to see if v11.5 has this feature or not. If it does, I'm shocked I haven't seen or used this feature before. Could you use the nesting feature instead of rotating and moving the letters through trial end error? Great video! I'm trying this this Sunday, even if I have to pay for the upgrade!!
@PawPawsWorkShop7 ай бұрын
Yes, absolutely v11.5 has this feature. I’ve used nesting and it works well. But for such a small project I would rather just place them onto the project board. Thanks for watching
@LYTOMIZE_Woodshop7 ай бұрын
So I discovered. Thank you for introducing me to it!!! 👊