Behringer Eurorack UB2442 "PRO" crusty fader repair attempt

[@felicidadenoar]

Por que não tem vídeos em português sobre essa mesa????

[@eddiekidd1760]

Yes, the knob pots are sealed ... So I just raised the knobs enough to get the straw under it. Then you can feel it release. After twists multiple times. But I only use CRC-QD electronics cleaner. It is Fabulous...E.L.K.

[@uk2011ful]

hi charger595 just like to know what size fader are to replace or have you got a link you can send thanks

[@lloyde2150]

How did you get the the wire for the lamp off? It’s the only thing on mine that’s attached to the outer case.

[@charger959]

I think it unplugs from the chassis. It's been a while so I'm not 100% on that. I didn't need to disconnect it to get to the top of the board so I just left it hooked up.

[@jonathanhoward5716]

Hey liked ur video. What kind of spray are you using? Did you use it only the switches and faders? Thanks for ur help

[@charger959]

MG chemicals contact cleaner and lubricant. If the pots weren't sealed I would've used it on those as well, I'm sure if one were to spray a small amount on the base of the shaft it might work it's way inside.

[@jamiestuart9171]

Curious if you could give me som advice on this mixer ?

[@charger959]

It's been years since I got rid of it

[@jamiestuart9171]

Well damn, I’ll keep diggin’ thx anyways 🙂

[@keopcp7769]

Giá mấy shop

[@Polyinstrumentalism]

*Mixer gets left next to the sump pump for 4 years* "Whelp, there you go, don't buy used Behringer" 😆

[@Polyinstrumentalism]

I may have a later version of this mixer; it seems that my pots are glued on. I tried some specialized prying tools (for phones and the like) and mine won't budge. It is very useful to know that the switches aren't sealed though, I think I will just drench them in Deoxit and it should work its way down. I picked up a very clean one of these for $40 and the some of the switches are a little dodgy, probably just natural oxidization on a 20 year old piece of equipment.