Best Dental Compressor | How to Solve a Dental Air Compressor Problem | Silent Air Dental Compressor

[@dr.mahendrapalsain5418]

Start hone meproblem ho .kya mistake ho skti h. Kya condenser cell change k jarurat hogi?

[@erkrishnakumarshrestha]

Please do the following: 1. AC voltage ( should be: 210-230volt). if the voltage range is ok, then 2. Change the condensor / capacitor of 25uf /400volt 3. If the step 2. does not work, then Please contact to the motorwinding mechanic.

[@rewashrivastav9607]

Sir chair ma jaane indicator ful red ma garsakyl tara compressor ma air pugeko xaina vhane kei prob xaina ni?

[@erkrishnakumarshrestha]

Please follow the following steps: There are two Pressure gauze in the Compressor. 1. pressure Gauze ( Large) : it measures the Air Inside / inner / compressor tank Air Pressure. Cut out pressure ( Auto Stop point : 8 bar and Cut In ( Aut Start point): 4 bar. Please check this phenomenon first. 2. Sometimes the compressor stops running before 4 or 5 bars. At that time please check the Electricity Power supply voltage. 3. If the above two methods/points are ok, But Tanky pressure is not increasing above 5 bar, Head motor is continuously running. Then Change the Compressor motor head. 4. If the compressor motor stops when Tank pressure Gauze needle is reached to 5 or less than it. Then adjust the Auto cut system ( Small black box ) to increase the tank pressure. There is another Pressure Gauze ( Small) with Moisture Trapper: 1. Maximum Pressure we can deliver to chair is 6 bar. The Dental chair pipe pressure capacity can hold this pressure. We can adjust from its adjuster given to the top. Thank you.

[@rewashrivastav9607]

Arko indicator ko k kaam ho

[@Dentist-ne7bo]

How to reduce the noise? Please help

[@erkrishnakumarshrestha]

Sir, there are few methods to reduce the noise. 1. Air Intake Filter: Please check this filter. If the air filter is ok then 2. Head ( Motor ) : Please change the compressor Head ( Motor ). If your Compressor has been running for the last 3 years then I recommend changing the motor head. Or 3. Install the compressor Away from the procedure room. or outside of the Dental chair room. Connect the air by Piping. Thank you so much sir for your inquiry.

[@hellangel230]

Compressor ma dental unit ko delivery pipe kasari fit garne ani washer bigryo bhane paucha ??

[@hellangel230]

REgulator bata hawa jane pressure kati hunu parcha hajur?

[@erkrishnakumarshrestha]

6 baar pressure when the compressor is full. Pressure will decrease while working on the chair. When Pressure decreases to 4 baar, the compressor will automatically start. And stops when it reaches 8 baar.

[@hellangel230]

@@erkrishnakumarshrestha 13.26 tyo regulator niskyo bhane how do we fix back? it seems that my regular cap has come off !

[@reyazahmed1780]

How to connect tube to compressor, kindly help

[@erkrishnakumarshrestha]

Thank you sir. To connect the tube or Air Pipe, you need a plier to do so. I will post another video regarding this issue also.

[@ku.bhavanisinghrathorerath6546]

Mera compresure awaj bhut kr ta h jor se bjta h kese thik kru

[@erkrishnakumarshrestha]

Please replace the Compressor Piston set or Compressor Head.

[@aliawan021]

how to control noise

[@erkrishnakumarshrestha]

Sir, noise comes from the Dental air compressor if the Motor is very old like 2 or 3 years later. Another reason is, the air input filter also helps to reduce the noise.

[@aliawan021]

@@erkrishnakumarshrestha thanks one video plz

[@sunilkarki5738]

thank you very much for your precious information sharing ,it means a lot to us :)

[@erkrishnakumarshrestha]

Welcome.

[@ambikadhakal1639]

Impressive !!

[@altimadentalcentre7880]

Dental chair 5-6 mae off ho ja rahi hae...

[@erkrishnakumarshrestha]

There might be a problem on electric power supply. Power supply voltage might be low. Second reason can be of the Cut-off system.

[@altimadentalcentre7880]

Ok rhankyou

[@md.litonahmedmd.litonahmed8246]

Price

[@dr.kaustavpramanik9396]

please make it in Hindi.

[@erkrishnakumarshrestha]

Ok

[@MJFurniture-vg4zo]

मेरो मा पनि यस्तै compreesor छ तर हावा धेरै kam दिदैछ kea6 यसको उपाय

[@erkrishnakumarshrestha]

Thank you sir for the comment first. I think, there are two options: Please check the first thing is: 1. ) Air Filter: It may be filled with lots of Dust. Please clean it first. After that please re-install in the same place. Does it work? If air fill up time is very short then its alright. 2.) The second and last option is: Needs to replace the Compressor motor head.

[@macadv736]

I wish this was english

[@erkrishnakumarshrestha]

Ok sure. I will upload in English in the coming days.

[@Smileawhile_23]

Compressor bata achanak thulo aawaj ma hawa gayo. Sabai hawa nasakinjel awaaj thulai aayera hawa gayo ahile compressor chaleko xaina k vayeko hola kasari samadhan garna sakinxa?

[@erkrishnakumarshrestha]

Please find out the location from where the air leakage is. Possible air leakage area : - Solenoid valve - The drain gate valve at the bottom of the compressor might be open. If it is open, close it please by moving 90° right clockwise. - If not solved, please do whatsapp / viber / video call at : [phone]

[@msknsng9476]

Sampark kaise kare mobile no

[@erkrishnakumarshrestha]

[phone] Nepal