Bestway Pool Vacuum Setup and Review - Costco Pool Vacuum Pros and Cons

[@antonioa6198]

Honestly best video for cleaning I couldn’t find any maintenance videos directly from Bestway 😢

[@deborahblanquie4998]

Thank you for sharing this video. It helped me get mine set up.

[@stellae_luna]

Thank u so much sir 🙏🏼 we would be lost without this

[@don_wynn]

You are welcome 😃

[@ninabarker1840]

Thank you so very much for this video! Best one explaining this set up and use.

[@maxgrossman5396]

This guy is my favorite reviewer!

[@therealvirgoqueen6553]

I AGREE MINE TOO BECAUSE IM OVER HERE HALF NUTS DEALING WITH THIS POOL

[@moonshotsilver]

The instructions in tte box were the worst ive seen. You saved the day Sir - Well done 👍🙏

[@sugarcanedi]

Thanks for reviewing this product. It’s nice to see that they can actually pick up a lot of dirt!

[@don_wynn]

Thanks for checking out the video

[@JamesSnider76]

The assembly instructions with this vacuum are super tiny and hard to read. This video was very helpful for a quick and easy setup. Thanks!

[@don_wynn]

Thanks and thank you for watching 😃

[@justjacksholden4108]

Thanks so much for this. I couldn’t figure out the instructions at all

[@don_wynn]

You’re welcome. Thanks for watching 😃

[@stephanelanke4984]

Good and very informative!!

[@victoriaamazonica3065]

Save me the trouble. Thanks for the review.

[@TroySteele17]

I really don’t care for this product.. But it looks like I’ll still be using it this weekend

[@experiencingislam5996]

Thank you for these instructions.

[@don_wynn]

You are welcome. Thanks for watching. 😃

[@genialcrony]

Thats a great demonstration video, thanks

[@don_wynn]

Thanks 😃

[@jaywarren3505]

I just unscrew my jet port and swap it with the inlet port when I vacuum. this way I don't have remove and replace that set screw every time.

[@don_wynn]

Great tip 😃

[@RichardBaileyrichoncode]

Any issue using with sand filter still in loop to filter out finer silt?

[@llee38]

Thanks for the review on the product, I thought it was helpful for me in deciding to buy it or not.

[@don_wynn]

Thanks

[@emmajean8724]

I have 2 B ports, which one should I use? Does it matter which side?

[@gracefulspiritandray6889]

Thank you for sharing and the review.

[@don_wynn]

You’re welcome. Thanks for watching 😃

[@jonjacob1962]

Just take off the piece that contains the filter bag and just let your filter do the filtering... That's kind of what it's for... That negates the need to clean the filter bag repeatedly as well as possibly improving suction. You can always backwash the filter a little afterwards to clean out some of the debris but most of it should get stuck in the built in skimmer basket on the motor.

[@MariaAlvarez-kt5fl]

I just bought this vacumm. If I take the part that contains the bag, what setting should I put my filter pump on?

[@deathwrenchcustom]

Right?? That's what I was yelling at my phone while watching this. Lol..

[@deathwrenchcustom]

The same function that you would use to drain the pool. Sometimes called waste. You can do it on filter, but you won't get as much suction and it's harder on the pump running it for that long with the added resistance of the vacuum hose.

[@Rogirlie]

Sorry, I strongly disagree and do not recommend removing the bag. You might ruin the pump.

[@Rogirlie]

I assembled it by myself using common sense and I see that I assembled it correctly, I am unable to remove the air from the host though, it is virtually impossible so I cannot make it vacuum I’ve tried what you say but there’s still a lot of air inside it.

[@emmajean8724]

Am I supposed to plug one B port and then use the other for the vacuum? I’m confused 😔

[@don_wynn]

Hi, you may have to use the flow restriction knob that they are included with the package, for the other B port to increase suction. But the answer to your question is yes plug it into one of the port B. Hope this help 😃

[@lasar0682]

Don't do "recirculate"! Then you are taking everything that you vacuumed and sending it right back into your pool, unfiltered. The only filtering would be that mesh bag with the big stuff you demonstrated. You could just run it on the filter setting. At least that way your pool return would be filtered. But the best way, especially with small silt, algae, ie stuff that would make it through your sand filter, is to put it on "Drain". This gives full suction, and all the junk goes out wth the water out of the drain port. You lose water this way, but it is worth it have alot of debris or algae.

[@therealvirgoqueen6553]

So put the pump on recirculation to use the vacuum???

[@don_wynn]

Hi, yes 😃

[@deathwrenchcustom]

If you use that silly little trap that he connected to the vacuum head. Better to throw that part away and run the pump in drain mode.

[@lasar0682]

I would not recommend that. Then the water returns to the pool unfiltered. If you use the normal filtering mode, suction is lower when filtering, but you will also keep your filtered water. I would use "Drain" as the other commenter recommend. You lose the water you are sucking up, but you will have cleaner pool.

[@phillipcrook8336]

Will it suck up sand?

[@don_wynn]

Yes, both sand and gravel

[@phillipcrook8336]

@@don_wynn thanks for replying 🙏

[@alexandertorres4989]

Do I need a vacuum ?

[@don_wynn]

Hi, it hooks up to the outlet of the pump so that provides the suction. Otherwise yes, you’d need some sort of device to hook up to that does the same.

[@therealvirgoqueen6553]

OMG THANK U BECAUSE I WAS GOING NUTS ABOUT THAT ADAPTER BUT THX U BECAUSE NOW I OFFICIALLY CAN GIVE MY POOL A NEW NAME BESIDES THE POOL FROM HELL 🤣🤣🤣 THXZ U #HALFNUTS 🙏

[@Jennifer-mf4rh]

In my opinion, it's quite bulky and not ideal for daily or even bi-weekly vacuuming. I take the hose and put one end out of the pool (downhill) and use my garden hose to shoot water into the end that goes into the pool. This creates a suction. Keep the end of the hose underwater use the open end of the hose to vacuum the debris out of pool. I've also attached it to the vacuum head and used it that way, as well. Here's a great video I found that explains it: kzbin.info/www/bejne/apabYmOeZbhkarc

[@yiss7546]

Me parece que voy a probar tu manera . Parece que no le llega mucha fuerza de absorción a la aspiradora . No recoge casi nada , es desesperante .

[@yiss7546]

No se puede ver el video de KZbin, dice que es privado.