How To: Autonomous SmartDesk Core Assembly

[@rahilshah4965]

What size are the 12 O.Screws? I purchased the used desk but I misplaced the screws during transportation. Thanks!

[@Azap313]

0:53 im screwed already. I don’t have a table to put my table pieces on 😢

[@edwardjames1768]

Pro-tip - in step 1, when stretching the framework to the desired length, make sure the inner sleeves of the support rails are centered so that all 8 4mm tightening bolts actually engage against it. Orherwise your just doing up a bolt into thin air.

[@jamesmadison3108]

Hi, I never seen u guys did a topic on "how to cover up scuffs for a used aeron?" . It will be interesting to know which touch up paint to use to paint the most common graphite aeron classics. A topic for your next videos

[@miniDrew4]

Autonomous messed up this assembly process so badly. My frame looks nothing like that in the box, and there's no clarity on what size to make the frame.

[@Dai5683]

The last hole on my desk do not line up. What should I do? I’ve tried readjusting the for one side and then the other side is off…

[@joaoramos32]

I had problems aligning several holes. There's 2 in the middle section wich to not align at all... did you manage to solve that?

[@yuryd1527]

I pulled the wires of the keypad (control switch). Could anyone help me to know which wire from connector (RJ-50, 5 different color wires) connected to keypad electrical board (5 points: Sleep, GND, TX, RX, 5V)? Just open keypad and take a photo. Please share your knowledge, or photo!

[@ahmedbishree9429]

Hi, which color is this plz?

[@hz2204]

how do you flip the desk? That's the hardest part because it's haevy as hell

[@edwardjames1768]

Attach the top once you've flipped the framework over instead.

[@yigitmeister]

very clear and helpful thanks.

[@jasonyoung7937]

Really useful, thank you!

[@edwardjames1768]

You put the control box in the wrong place. Its meant to go inside the 2 rails. Not behind or in front. Youll notice on your control box it has a center mounting hole on one side, and an offset mounting hole on the other. Youre supposed to mount the box so that the center mounting hole lines up with the small hole in the plate that runs between the 2 rails. You have one on each side for extra choice. You then dont have cables running over rails as well. And also provides a small bit of play so you can plug the cables in and out a little easier and they arent conpletely flush to the underside of the desktop.

[@thesouthpole3915]

I would get one but there is no cable management available!

[@walterramirez6665]

My cross piece isn’t closed off on its sides. Am I not see the right video??????

[@tyronelaces8690]

Soooo disassembly. Not going to be easy 😢