Thanks man I really appreciate the motivation! I sure will already going to take apart tmrw for another video! New vid up in two hours!
@Pacman24k Жыл бұрын
Thanks for the video I was going grab the same kit for my drz
@tevincurry15213 жыл бұрын
Keep trying it will start !!! I’m not joking even try some starter Fluid I had the same problem me and my buddy kicked this thing for a hr and it fired right up and after we drove it around for a bit we still kinda struggled with the start I gave the carbs a clean and bam it fired 1st kick every time also when you first start it don’t let it idle long it will get hot !
@youssefbilal46042 жыл бұрын
did you repair it? i have the same problem with the big bore kit?
@kikemotors61382 жыл бұрын
No i did not yet , where did you get yours from?
@kontrollme90343 жыл бұрын
Not surprised after rebuilding bikes sometimes they don’t won’t to start
@andreibucsi60373 жыл бұрын
Hello! now does the atv work with that set? I also bought an engine set from ebay
@kikemotors61383 жыл бұрын
It worked okay but my head is a lil warped so that's what caused my issue . There are some things that work great and some don't best to read reviews and check star ratings
@jessecrawford2711 Жыл бұрын
Poor fella sounds like it was outta time and yea the rings may be a issue I used a cheap kit but used a namura piston, use a namura piston
@kikemotors6138 Жыл бұрын
Runs great with same kit I got it to heat up and seal
@jessecrawford2711 Жыл бұрын
@@kikemotors6138 nice
@robertoguerrero40433 жыл бұрын
Mine makes the exact sound bout doesn’t turn on at all. Can it be the starter clutch or valves ?
@kikemotors61383 жыл бұрын
It could be low compression maybe valves to open?
@GR-Z3 жыл бұрын
Dang that sucks man. Any update on this one?
@kikemotors61383 жыл бұрын
Not yet if I get a chance might open it up this weekend il keep you guys posted
@briancrow48283 жыл бұрын
The head is probably warped and the head gasket probably didnt seal properly. When you did the leak down test before if the head gasket was blown it would leak there. Probably need to get the head professionally resurfaced. Or new head but dont give up brother.
@kikemotors61383 жыл бұрын
Thanks man I will try not too haha but yes I think it is warped if not maybe needs to be resurface a bit but good idea with leak down test
@lt-z-quadnation66443 жыл бұрын
I hope you didn’t give up on the Z-400’s ?!? Those water pump rebuild kits you did in the last video are just a bad idea and a pain. I just do the whole water pump assembly as it’s easier and gives me more of a piece of mind. 🙂
@kikemotors61383 жыл бұрын
Nope I still got it!
@macfpv033 жыл бұрын
Your best be is to get a wiesco gasket set thats what ive seen on the forums for the ltz and drz with the cheap big bore kits the gaskets aren't that good
@aaroncarterevans3 жыл бұрын
you shim the valves to spec?
@kikemotors61383 жыл бұрын
Sure did
@kontrollme90343 жыл бұрын
And that’s what exactly my ltz 400 sounds like because it don’t want to start. And I didn’t even rebuild the engine
@kikemotors61383 жыл бұрын
Ya man very frustrating ! But oh well try n try again
@chrisd33993 жыл бұрын
Wanna sell it?
@kikemotors61383 жыл бұрын
@@chrisd3399 for how much
@andreibucsi60372 жыл бұрын
It’s runnig now?
@kikemotors61382 жыл бұрын
No but it will be back in the garage soon!
@andreibucsi60373 жыл бұрын
Hello!i montage the kit, I have a problem with antifreeze running on my cylinder and cylinder head! to be the problem with gaskets?
@kikemotors61383 жыл бұрын
That's what happen to mine I'm actually pulling it into the garage to figure out what the problem is going to be but I'm almost sure the head is warped or needs a little resurfacing I did a previous video resurafaving mine just a bit but I think it needs more under how to resurface old quad head
@andreibucsi60373 жыл бұрын
@@kikemotors6138 i think the problem is gasket..
@richardtschida23213 жыл бұрын
Sorry to say it but the motor is trashed and will never run.
@Willisfitner2 жыл бұрын
🤦🏻♂️
@richardtschida23213 жыл бұрын
All of your close ups are always out of focus and it's very annoying, focus man!!
@robertowens868 Жыл бұрын
Blown hg
@kikemotors6138 Жыл бұрын
Resurfaced the head and fixed it now
@andreibucsi60373 жыл бұрын
Hello! now does the atv work with that set? I also bought an engine set from ebay!?