Black Tank & Gray Tank(s) Level Sensor Installation

[@wildcat8025]

Great job explaining things. Thanks for the lessons.

[@harjeetsinghmakkar5177]

Great video. not exactly what i wanted but good things to learn like length of wire

[@sierradenali3270]

Great job Danny, while you have the interior removed, perhaps you might consider installing the wire harness for a future interior/exterior camera.

[@THEENERGYINHALER]

You didn't show wiring at all it was just done... What's inside that little red harness that the sensor wires go into ...Circuit board? Does the display panel know how deep the water is with only the red and white wire?

[@dcdvs1583]

The first three and half minutes of this videos I broke down a full explanation on what each wire was in the harness and where it hooks up including all wires(including the 2; the red and white wire) that did not have eye terminal rings which go back to the monitor. At minute 5:30 I actually hook up the wire harness to the tank sensors that I drilled out and talk about each color and what sensor it’s hooking up too. I have not shown how to actually wire the monitor because that will be towards the end once I have interior walls in and framing starts happening of walls, cabinets etc. the little red harness is built by the company and will read correctly once hooked up and tank fills appropriately. I’ll have a video at some point that will explain the wiring of everything for this trailer and each component.

[@junkyardvinyl4811]

Danny, are you going to have a way of flushing out your black tank ie a water inlet?

[@dcdvs1583]

Great question. Yes I will and will be doing a quick 5 minute video soon on it. If you watch this video in the beginning with the black tank you will see on the right side of the black tank a very large opening to the frame as well as to the ground. At the end of this video where the water is pouring out just to the right of that 3 way valterra hub you will see a hole already pre drilled out. Thats where the water valve inlet will go and I will be installing the valterra no fuss flush with check valve in that opening on right side of tank. Still waiting on delivery of all three valterra valves. The gray tanks will each have one that will actually install on top side of tank like a reverse sprinkler and those will be accessed from a same port on outside panel of trailer that will also have access through bottom of kitchen cabinet as a secondary three way with shut off. If all that makes sense. Apologies for long response.

[@junkyardvinyl4811]

@@dcdvs1583 Thanks for the info.