looking good! makes me want to get into helis again
@StefanFinster4 ай бұрын
love it, I like mine more and more, want to get some flights on it but still only rain for days here
@CoeShow6194 ай бұрын
@@StefanFinster I like it man. It’s gonna be a beast.
@nsbob704 ай бұрын
That's just nuts man.
@K-B-C4 ай бұрын
Okay Justin...... I know how much you love your 700X..... So how about some comparison flights !
@CoeShow6194 ай бұрын
She’s in need of electronics. Here’s the flight from two years ago. Taking it easy on tail gears and the last torque tube on earth. kzbin.info/www/bejne/n6WWdZmZjNBsqq8si=zdLtVLq5c5YRahpY
@Robzenith601xlb4 ай бұрын
Hey CoeShow. Do you get a hot motor? My 700fusion is ready for maiden but seems to get a hot motor just ground running at 50% throttle with no baldes.
@CoeShow6194 ай бұрын
@@Robzenith601xlb it’s because without a load that motor freewheels and has no load. When loaded and in the air it will be about 120 degrees after landing. Check all function before flight.
@CoeShow6194 ай бұрын
Haha. I just woke up. Just run it.
@Robzenith601xlb3 ай бұрын
Maiden today, heli hovered for 20 seconds in idle up 1 then shut off with BEC still functioning but no ESC function at all. No drive line binding. 120amp Avian super combo. Any ideas? Felt very stable and very quite before I needed to auto from the ESC failing. Avian prog has disappeared from my radio.
@CoeShow6193 ай бұрын
@@Robzenith601xlb put in Store governor mode with a programmer. Then do this. kzbin.info/www/bejne/m2Kbd4JubLh1e5Ifeature=shared
@Robzenith601xlb3 ай бұрын
@CoeShow619 hey mate, thanks for the reply. That is what I did. I didn't change any governor settings in forward programming I did exactly what that video showed. Then when I took off and hovered after 20 seconds she just died. Now my ESC won't even connect to smart programmer or my radio and the motor will not beep when the battery is plugged in. This is the second 120amp ESC that I've had this happen with. The first one didn't even get through the 50% calibration before it also shut off.
@ronaldjones87974 ай бұрын
Build it and they will watch. Hope all is well.
@alignwelding61604 ай бұрын
What size pinion did you use 11T or 12T
@CoeShow6194 ай бұрын
@@alignwelding6160 12 tooth. With stock 18 tooth tail pulley.
@alignwelding61604 ай бұрын
@@CoeShow619 nice thank you SIR !!!
@CoeShow6194 ай бұрын
@@alignwelding6160 now go get down with that Fusion.