Watch the entire Blanket Chest Video series at: • Blanket Chest Project ...
Пікірлер: 22
@thedyslexic99365 жыл бұрын
Great video.
@InsaneOil5 жыл бұрын
You can watch all the steps on my Blanket Chest Project Playlist... kzbin.info/www/bejne/qajOdIp4hsqEjac
@chatteyj5 жыл бұрын
@@InsaneOil Is this the only way to install a hinge on a bench/trunk? I want a hinge on my storage bench but don't really want the hinge sticking out the back so I can have the bench flush against the wall is this possible?
@InsaneOil5 жыл бұрын
@@chatteyj They sell all different types of hinges. There should be one available that doesn't stick out. However, the one shown in the video needs to hang over.
@Samlol23_drrich4 жыл бұрын
Excellent. You seem like you know what you are doing. I am clueless and cannot find the answer to this basic question. Suppose I want the hinge side of the chest lid to have a 2 inch overhang instead of being flush with the end of the chest as you did here. Would this type of piano hinge still work if you slid the lid under the chest by 2 inches and drilled the pilot holes 2 inches from the lid edge? I don’t need to go past 90 degrees. Thanks for any help..........R
@InsaneOil4 жыл бұрын
It should still work, but as you noted, it wouldn't go past 90 degrees. Just make sure the hinge pin is hanging off the back edge of the chest side.
@Samlol23_drrich4 жыл бұрын
@@InsaneOil thank you very much I appreciate it
@kathywinn68693 жыл бұрын
samlol23, I want to do the same thing so I’m curious about whether that worked for you. Thanks.
@JohnDrach3 жыл бұрын
Tip: Set playback speed to 1.5
@InsaneOil3 жыл бұрын
Or if you really want to get crazy...set it to .5
@drewtheman972 Жыл бұрын
Such a good video
@InsaneOil Жыл бұрын
Thanks for the comment. Much appreciated.
@ajones12743 жыл бұрын
great quality work, one thing i would have done is used a different hinge so it was more discreet
@InsaneOil3 жыл бұрын
Agreed. There are many options when it comes to hinges. I was going for low cost with this project.
@stephencraig85782 жыл бұрын
Is there a way to make the hinge invisible on the backside?
@InsaneOil2 жыл бұрын
I'm sure some company out there has created a hidden hinge. I don't know off of the top of my head without doing a bunch of research.
@stephencraig85782 жыл бұрын
@@InsaneOil ok,thank you
@lauried.27082 жыл бұрын
@@stephencraig8578 I got it to look nice. Only 1/8 of the hinge shows. I mortised out one side.
@kennethlee776411 ай бұрын
Hinge is backwards. Screw goes on a beveled hole.
@InsaneOil11 ай бұрын
The hinge doesn’t fold the other direction.
@88blackandwhite883 жыл бұрын
Are you a shop teacher? You speak like an instructor of children. Regardless, nice video.
@InsaneOil3 жыл бұрын
Yes, I am a high school shop teacher...perhaps one of the most exciting shop teachers on KZbin.