Рет қаралды 7,333
An ebay purchase, after some initial safety checks I powered the chasis up via a lamp limiter. Everything seemed ok via the lamp limiter after an hour or so I then put full mains through it. Everything worked, no hum so the Siemans smoothing can was good as well as the Selinium rectifier. The chasis is a printed circuit board and all of the capacitors are of good quality WIMA type. All of the de-coupling capacitors and resistors in the output stage checked out within spec, electricly the chasis was working just a clean was needed.
The MW tuning gang was siezed which had resulted in a snaped dial cord which I replaced.
The Garrard Autoslim was fully serviced as the grease had hardend and the idler was treated with rubber renew. A new 78 and Lp stylus was fitted to the Ronette Stereo 105 turnover cartridge.