Blown RB25 Tear Down.. Time For Full Rebuild

[@Papiichampo]

lesson learned. but you got it.. clean up that engine bay too lol got a nest going on lmao

[@slow_sylvs9643]

Also double check your oil cooler lines and oil filter. Flush that oil cooler too

[@KyleAndersonSkates]

Nooooooo! Man this sucks, hope it all works out smoothly!!

[@thewraith6360]

Bro it doesn't make the sututu noise cause you don't have an aluminum intake pipe attached to the turbo, T51r mod has nothing to do with that, any turbo you put on it no matter the compressor side without an intake pipe its not going to do the sutututu noise. Look into the nitto extended crank collar while everythings at the machine shop rawbrokerage sells them both, that plus the head drain, N1 oil pump and bigger sump would pretty much bullet proof the oiling system on the RB.

[@VintageCR]

That rod bearing or bearings don't look too discolored from overheating which happens when there is little to no oil to lubricate them. it looks to me that at least one of the bearings(1 half) was already in bad shape and started spinning and morphing / melting into the other half. this can also happen if a rod stud nut/bolt isn't tightened all the way to spec, but then more things could go wrong so.. peach me its a mystery.

[@ntg44]

I admire your persistence. But through these videos I have pretty much determined that an RB is not for me haha. I don't think I'd have the personality to deal with these setbacks. But I will definitely admire your build from afar 😁.

[@myBEEFY1]

yea well it gets to the point where your way too deep to turn back haha

[@ImDasCute]

Make some tees dude I’ll buy