BMW E36 M3 - Engine Harness Connections

[@joelnevarez9128]

You're a Goat for this video

[@aSmokeyE36]

I won't even lie you have saved me 🙏🏾

[@ELY-qg2vn]

Super great video super helpful, great angles, great narrations. Thanks

[@tassospel229]

This video made my life so much easier thank you sir 🤝

[@cobymaane5648]

Thank you so much for your video. I had swapped engines on my 323 with a turbo m52b28 and after the swap the car struggled with cold starts and had a fluctuating idle. Threw a crank position sensor code and after swapping the sensor with new oem the code was still there. After watching your video I realized I had mixed up the wiring haha. Thank you very much!

[@BruceLeef]

Can the sub connection to an 02sensor downstream on a bmw x5 4.4.. be replaced with out having to replace the entire wiring harness

[@7beast298]

Hey bud at 7:30 do u mean gray wire and brown with a gray stripe?

[@jasonfance555]

What colors are the vanos 2 pin and dose it have 12v with the key turned just to on position. My mechanic didn’t wire me up right I figured out my check engine light, but I need to know where this 12 V goes.

[@carsonwlki]

i can’t get the power block off the ecu?

[@cbilii004]

do the color of the wires change between the ob1 and obd2 wiring harness for the m3? or do only the ends "connectors" that change?....

[@ConaStyle]

Great video it was very helpful. I'm putting I am swapping a s52 into my e36 and was confused. You didn't mention the other plug on top of the fuel rail, what does that go to?

[@IDJMK]

You probably already done this, but I’m doing it right now I’m pretty sure a connects to a solenoid for the vacuum lines.

[@exoticcarsdaily3366]

could you post a video on the wiring from the alternator to the battery? i replaced a new 140amp,pulley,and battery, bmw wants to charge 850 in labor to “check”, im 99% sure the wiring is corroded

[@xavhol8541]

Rats chewed my injector rail connecter, can I solder it back??

[@IDJMK]

Great video thanks for sharing your knowledge no, I’m not dead in the water lol

[@chideverett9580]

On my 97 328i m52 the crank sensor harness that goes from crank sensor to vanos and cam sensor there’s a third connector much shorter with two wires in a 3 pin plug and I cannot figure out where it goes

[@ELY-qg2vn]

You ever figure it out?

[@chideverett9580]

@ELY yeah bro it went to the main harness

[@irresolutemute129]

I also have a third plug and can’t figure where the heck it goes

[@chideverett9580]

@@irresolutemute129 it goes to the main harness from the car

[@irresolutemute129]

One plugs to the fuel rail other goes to vanso solenoid

[@Theoriginalmichaelmiachel]

Damn your cars clean