BMW K75 Engine Service Ep.1: Water&Oil pump revision

Water & oil pump revision:
Grit-blasted housing & repaint.
New seals, crush rings, removed some rust from the shaft.

[@hundefreundjames6592]

schöner Lehrfilm 😊

[@billkenney422]

Very helpful video, thank you for your time and effort. Anyone who bandages an injured finger with masking tape is ok in my book.

[@ambassadorkees]

No bandage can stand the stress of working 😅 I did a second one without the hammer, only a M8 bolt puller. Same result, but safer on the seal.

[@billkenney422]

Ambassador Kees I just purchased a 91 K100rs and I'm sucking up any knowledge about them that I can find. Thanks again, and yes I did subscribe so you'll probably hear from me again. A pleasure to meet you, Bill

[@nicolasdeneriaz3689]

Hi, very clear video, thanks. The adapter you designed looks great. I installed my water joint with a socket and it split up the joint in two. If anyone knows where it would be possible to get an adapter similar to yours on the net I'm interested.

[@user-mm6dn4ix4h]

Do you have to drain the oil aswell as the coolant Thanks

[@ambassadorkees]

I did. Any engine work is a good reason for an oil change. However, the oil sump level should be lower, it is sucked in through a pipe bend.

[@mruniverse5704]

Hi again. Could you tell me pls, i have 1 scratch around the circle on the engine block right on the edge of the main oil pump gear. Is it ok?everything else looks fine. And one more question you have 32 Teeth main gear and that little half-moon hole above the main gear, what if sealant accidentally fill this hole a little bit and how avoid it? And that noise is making me crazy kzbin.infofwC3VUNJf8U?si=wapj4VtormYctxln

[@mruniverse5704]

Hi👋 Can i replace that seal without special tool?

[@ambassadorkees]

Using a suitable socket will work, it has to press on the outer ring. The tool just helps ensure all's centered. When using a socket, I suggest not using a hammer, but M8 bolt for pulling in or a vice. You may stack multiple sockets to cover the length of the axle.

[@mruniverse5704]

@@ambassadorkees Thank You. I think the same about m8, not to smash, just pull it in.