BMW -Turbo Inlet Install (Pure Turbos inlet pipe) e92 335i n55

diy how to install a turbo inlet pipe on bmw e92 335i n55.
thanks for watching
Subscribe for more videos

[@yungxsixbigswagdady6970]

Just what I needed, great video.

[@DorianBudana]

Thanks mate, appreciate 👍

[@tawandamanyanga6727]

It looks sick bro all about the power 😜😆

[@DorianBudana]

Thanks🤩🤩🤩

[@ArisFilms]

Very well put together video. How did you figure out your inlet had an air leak?

[@DorianBudana]

Hello, thanks I have tried my best... Regarding the air leak ,I did an smoke test with a device which I made myself...watch this video...to see the leak Thanks kzbin.info/www/bejne/j2HGnYmfedulmqs

[@ArisFilms]

@@DorianBudana I made one too, I’ll reply again to let you know how it goes

[@jrelyea]

Where did you get that rubber hose that you used to replace the terrible plastic heater blow by hose? I want to do that so bad.

[@DorianBudana]

Hello , that hose came with the mishimoto catch can .

[@blackjackYGCM]

did you notice any hp gains or more turbo sound?

[@DorianBudana]

Hello, I don't know for sure about hp but car feels faster at higher end, and is more turbo sound now, especially for me cos I add an injen cold air intake...

[@bazzduro2181]

where did you buy? I would like to install on n55 335i Xdrive 2011

[@DorianBudana]

Hello, from mlperformance.co.uk

[@JB-B58]

7:40 did you get the part number for the seal bro ?

[@DorianBudana]

Hello, no, it's been fine since, no air leaking ,so I didn't have to replace it

[@JB-B58]

@@DorianBudana okay thanks for your respond and video champ

[@E63Isaiah]

Where did you purchase this because for some reason to google this part is non existent on a bmw 335i e92 n55.

[@DorianBudana]

Hello, I bought it from mlperformance.co.uk

[@Bmwtuner]

Did you get check engine for the air leak ?

[@DorianBudana]

Hi, no I didn't got any check engine mate, the only thing I had it was a bad cold idle......that was what it make me look for air leaks....I still got that surgical idle when engine is cold ...but it improve a lot when you wot the car...

[@sanilaca]

@@DorianBudana Check your PCV Valve

[@OGYELLOW]

What type grease applied?

[@DorianBudana]

Hello, I use some lithium grease...

[@williamdiaz8100]

Where I can buy the inlet?

[@DorianBudana]

Check on mlperformance.co.uk

[@williamdiaz8100]

@@DorianBudana thanks

[@JAydUBr6]

How were your results?

[@DorianBudana]

Hello, I like it so far, car fell quicker at top end, and the throttle response is better, I have installed an injen intake and is fitting great with the inlet....all in all I like it

[@chrisnista7928]

You sounds Romanian

[@DorianBudana]

I am mate😃

[@chrisnista7928]

How did you get the new gasket on it is very tight no?