Bosch Angle Grinder GWS 6-115 - Bevel Gear Replacement

[@atexc5604]

Great way to destroy your axle(just like you did :P). If you have bearing separator AND bearing puller then just simply hook puler to the separator. If you have only separator just clamp it like you did and then use 2 screws, and ~10mm steel bar to push the axle. Separator have 2 vertical holes, one on each side - use as large screws as possible. You need to drill 2 holes in steel bar in correct distance to push that axle. If you don't have separator / puller you can use long socket and hammer, but please use at least copper coin on top of axle to not destroy it like on this video.

[@renatoarrighi5637]

many thanks for your help. now I can repair mine with same problem. thank you so much- renato Italy

[@cyberbunny100]

You are welcome.

[@ezrika0257]

the gear housing, can fix other brand ?

[@ezrika0257]

can use any type of greese oil ?

[@cyberbunny100]

No, a special grease is specified in the operating instructions.

[@LuisGomez-vu6wg]

Muchas gracias por el video es de gran ayuda Dios lo vendiga

[@aegonwelding6199]

Where you got this gear

[@cyberbunny100]

Hey, Bosch has a very good homepage where you can reorder almost every part.

[@aegonwelding6199]

@@cyberbunny100 website konsi hi

[@samuelfabio7002]

Ok! Muito bom mesmo! Valeu 👍👍

[@horiachiorean8592]

You need to put a little more grease

[@cyberbunny100]

Thanks for the tip.

[@robertobezerra8376]

Ótimo trabalho parabéns 👍👍

[@cyberbunny100]

Muito obrigado.

[@ЕвгенийГорбачев-е3ц]

Техника ,на высоком уровне разборки ушм блогадарю, учус.

[@diymaster101]

Thanks so much it worked 👍🏾

[@blablablabla9920]

Super Job , ich hab ein PWS 620 , das was Sie repariert haben , ich meine die Kugellager ist defekt die mit Getribe (abstands metal ist kaputt und die kugellagern die bleiben alle zusammen .

[@DanielMartinez-sw5bz]

Destruido el eje por los golpes, bruto... tendrías que usar un punzón o un extractor de ganchos.

[@leonardochavez4799]

golpear directamente el eje para que salga no es algo tecnico, ya que deforma la punta del eje, si se cambia la corona se debe cambiar el rodamiento

[@greenpanda84]

Thanks Man!

[@mnarsk5853]

।। 🎉ট।😊

[@musichillsrecords3065]

wrong fitting