How to replace stubborn wheel bearings on motorcycles

[@macca462]

Did this job a few weeks ago on my bike!

[@EricBanner571]

FYI, Bearing manufacturers do not over pack the bearings with grease as it will cause drag and heat. I use to have the same philosophy as you but sometimes less is more.

[@advsquared]

It's amazing that you can buy a new bearing that has almost no grease. Makes you wonder what other short cuts they're taking.

[@BrokenSprocket]

The bearings that came out of the bike were bone dry.

[@2025944]

Does it matter which side of the bearing sticks out or goes in

[@muddyboots-mac]

nice content, at 3:42 when you remove the spacer, it comes out easily, is that a sign that the seal has worn out?

[@BrokenSprocket]

Yeah mate probably

[@KennSlime-w3x]

What’s the size of your bearings

[@ilham7345]

how long did you torch it out?

[@BrokenSprocket]

Just needs to get some heat in it not to much

[@inthepumpkinpatch5383]

This should help!!!

[@ivanrybkin9384]

if you can move the wheel the way you do, then your bearings are waaaay loooong gone....

[@jerryjohnson9044]

If you have a MIG gun run a beed around the inside the outer race