Browning BL-22 Assembly and Disassembly For Cleaning.

[@denisekell4872]

Broken firing pen. Thanks for the video. Great job 👍

[@glenbuyer8738]

Thanks man, there’s limited content on this subject so very thankful for the video (edit) BEST VIDEO IVE SEEN ON THIS!

[@mynameisfrank6519]

Thank you so much! That was impossible with out you!

[@ericlondon5731]

I am a FFL gunsmith for past 30 years. This gun has been on my list for being overly complicated . Yet, it is mechanical sound and only ever had to clean four. Nothing really happens to them otherwise.

[@kevingoldwing]

I installed my ejector spring and ejector with a little gun grease to hold it in place. Only two attempts to get put it together.

[@jasonscott5043]

You don’t have to remove the stock to do that. Just leave it attached to the action.

[@Boo8087]

My ejector spring got bent then lost straight after today. I gave up. Buying a new one online and letting someone else put it back together

[@danhealy7341]

I have been considering buying one of the BL-22 rifles. The receiver is steel but does anyone know what the internal moving parts are made from? I’ve heard they are aluminum but hope this is not true at the price of this rifle.

[@humorss]

gotta say browning guns are not the easiest to disassemble, you need all the small tools and improvise, but works wonderfully.

[@DevinBauer]

Actual JM Browning designs were often straightforward. 1911 and SA-22 are both wonderfully simple examples

[@irishkelly654]

I have 2 of these BL-22's, both have feeding/cycling issues. Sometimes the rounds won't cycle properly and I have to use a knife or screwdriver to help (nudge it up a bit) to get the round into proper position to close the lever/bolt. Do you know what would cause this? Thanks very much in advance, cheers...

[@EasLosKing]

Mine was having light primer strikes sent it back to browning and they sent me a new one. It was within the year of warranty

[@joshuaobrien9779]

Do you have to strip it down this far to clean the barrel every time?

[@apexcustomrifles]

No, you could get away with running it through the muzzle end first and exiting the chamber end. They sell little bronze coned bore guides for this purpose so you don't run the risk of damaging the lands near the crown.

[@arildjohansen1574]

Hello, I have a brand new Browning bl 22, should I open it up and oil it before I use it?

[@arildjohansen1574]

@old rabidus you have a point there, thanks for reply☺️

[@sandogtjsandog4366]

Maybe you should have also shown how to free the magazine tube to slide it forward, removing the fore-end and barrel bands. There is a set screw inside the bottom/front of the receiver that needs to be loosened to slide the magazine tube out.

[@REBELSCL]

Think I’ll look at a Winchester 9422….

[@rosewhite---]

Amazing but ridiculous amount of machines parts in there! Would a three shot revolver shotgun be a lot simpler to make?

[@rosewhite---]

@@glenbuyer8738 my aren't you the genius!

[@kavak1344]

I've been shooting mine 15 rounds at a time for 34 years now with no issues and never had to open it up, so they knew what the were doing with all those parts

[@graybeard7408]

Not any more difficult than re assembly of a Marlin 60

[@longang7926]

Thật tuyệt vời giá như tôi có thể mua nó ở trỗ tôi