Buck Converter Circuit Simulation [Altium Designer]

[@hamedavazeh2463]

Thank you for your excellent videos, sir. But the real solution to the mentioned problem is that the "pulse" should be applied to the gate-source pins of the MOSFET not to the gate pin and the circuit's ground. if you apply the pulse to gate-source pins of the MOSFET, you won't need high voltages for the activation pulses.

[@techedkirsch]

Yep that's true. I'll remake the video (I had the same problem in the lab in 2017 but didn't put that in this video for some reason).

[@alvarodemontes3818]

Thanks to you i realised my 1st Altium simulation.🙂

[@techedkirsch]

Nice 😎. You’re quite welcome

[@hamanhnguyen2025]

I can't find VSRC in my components so how can I make voltage source like that ?

[@davidmaruska1641]

Nice video again Kirsch!

[@AB-yu2tj]

That you for this. I can not find the input or output power, I think you called it vsrc

[@techedkirsch]

You're welcome. Still can't find power you said?

[@gearoidwhelan5552]

Thanks for the video. If you were to take this design to the PCB, what's the best method for this. I know you can't take the schematic as it is now and bring it to a PCB because there's no footprints for the voltage sources. Are you better off having a copy of this schematic with no voltage sources and bring that to the PCB then, or is there a way to bring the above schematic to PCB and just tell Altium to ignore the components without footprints?

[@gearoidwhelan5552]

@@techedkirsch That worked out really well for me. I couldn't find any info about this or I didn't know what to search for online. That's very handy! thank you so much!

[@canmemis3951]

Hello, how i can contact with your?

[@diyelectronicstelugu]

Thank you , I'm looking for it ....

[@blessingstchidanire8025]

Am i able to do it on multism

[@techedkirsch]

I’m not sure. Never used it

[@TanzimMeraj]

yes you can

[@Narsadi]

Altium is not capable in simulations unlike Orcad pspice. One example: i simulated amplifier circuit in Altium. Result was nothing close to the one i got in Orcad. Then i exported the netlist directly to ltspice. And the result was very close to what pspice has achieved. I’m done with Altium simulator. Altium doesn’t cope with transistors in the right way

[@Narsadi]

@@techedkirsch , i'm diy audio hobbist. And to me the simulation capabilities are vital.