Budget Waveform Generator Review

[@junctek7696]

Thank you very much for your support, the video was shot very well, and I look forward to cooperating with you.

[@HTMWorkshop]

Thank you! Look forward to working with you again.

[@cajuncoinhunter]

@@HTMWorkshop Yes you are correct about the MOD feature having to do with radio and radio communication , many moons ago my old HP did the frequency to the D.U.T. with a 1KHz tone at 30% modulation with a 1mV output level for the audio output ..... Then the same setup for the receive sensitivity except for the RF output level at 1.0uV....... I don't know if this unit you are reviewing does RF at that low level, I am researching that , and that's how I found your review on you tube......Maybe @JUNCTEK will see this comment since I posed this question in this area of comments..... OR if you know the answer that would be very helpful.... I plan on buying the 60 MHz or 80 MHz model next week.........BTW that ringing you saw on your scope @12:47 time stamp is probably the supplied BNC-BNC cable , switch to a RG316 type 50 OHM cable and it will more than likely disappear , I have seen that before ..... Take care Mon Ami ....

[@HTMWorkshop]

@@cajuncoinhunter Yeah that is good question - I am not sure if it can go that low - but for the price its worth a shot. Great point on the BNC cable issue! Thanks for the tip!

[@uni-byte]

Most higher end generators (let's say $500 and up) are ground referenced. With this one you can run it off a battery pack and have it fully floating if you wish.

[@ronjones4069]

I expect the square wave ringing may be because you didn't terminate the line.

[@uni-byte]

That would also explain some of the voltage variance in the higher frequencies too.

[@richardshort4587]

Would this instrument provide a frequency tone for radio rf alignment. I ask as I’m a complete newby looking to set up a small work station. Sorry if the question is a dumb one.

[@nwmi493]

would this be something I could use to tune car audio with? Use the generator to output into the head units auxiliary input ? ie 1000hz, 40 hz 0db ?

[@ВолодимирК-р6т]

Is there any noise during work? According video - it is silent.

[@HTMWorkshop]

Yes I believe there was at high frequencies

[@Mark-hb5zf]

Very well done review.

[@HTMWorkshop]

Glad you enjoyed it!

[@forbeginnersandbeyond6089]

Junctek is so self-unaware that their name is a big problem. I think they should ask an American/British/Australian etc native English speakers about their brand name before they put it on their product.

[@HTMWorkshop]

Ha, yeah I definitely thought the same thing. If they rebranded for the U.S. market I think they would do much better.

[@juanmf]

The app is giving me file data error for every attempt at importing a CVS, tried several formats: format 1: SIZE:,41250 FREQ(HZ):,5500 Vpp(V):,2.5 Index,Value(-1.0---1.0) 0,0 1,1 2,1 .. format2: 0.000000,0 0.000182,1 0.000364,1 ... format 3: Time (s),Amplitude 0.000000,0 0.000182,1 0.000364,1 ...