How to install an Easy Drain, clip together drainage

[@jeanrafes]

A good idea is to cover the grate with tape when putting in the cement, then remove once the job is done and dry. Saves cleanup

[@toddmichon]

Always good to go back when it's raining to capture footage of the drain working to show in the video.

[@calvancandy8384]

Get yourself a mortar gun for filling in the sides saves a lot of work - great video 👍

[@kathrynleaser5093]

Good tip...thank you.😊

[@maxiscooterridescapetown-g2217]

This is my nexj job to tackle before winter returns....

[@larrypoole3906]

Great work. Put some masking tape over the drain during install to keep the concrete out.

[@davidwallace8937]

Good guidance for me. Thanks.

[@emanibrahim7275]

Wonderful video wonderful work it looks very good

[@deirdremkenny]

Great video, thanks so much for sharing

[@diskonekted3724]

Hello, great video - many thanks for taking the time. A question, you're using a 110mm reducer, but doesn't the end cap take a 90mm socket?

[@cameronmckendrick1464]

How much would a job of this size typically cost if hiring someone?

[@bytejuggler]

Nice job, thank you.

[@Gert834]

Why do the channels bend upward after clipped together? When you clip more than three both ends bend upwards. If you press it flat it just disconnects

[@Nmag27]

For long runs, I think I've used 3 m lengths. Less joints = better

[@jddownes1]

What size grinder blade did you use to cut into the concrete?

[@DeanPhilips-pr3hl]

Its meant to sit on a concrete bed not mortar. Why mortar bed?

[@mrjweate]

I have a bend in my trench. I need to connect 2 drain pieces at a slight angle. How can I do that?

[@Nmag27]

I've cut them with a circular saw before and finished with a handsaw. I cover all external parts of joints with cloth tape before pushing into mortar/concrete because even the clip-together joints are not sealed enough to prevent a little slurry from entering the joint when you're pushing it down in case a long drain flexes a little at a joint. So tape your joint on outside or care not to overfill bedding and place each section in, then silicon your joint from inside before filling sides.

[@jamesgallagher3317]

If you left my drive looking like that with patches of cement everywhere you'd be paying for the removal of the patches. A good job is a tidy job and that is far from tidy

[@vickipps6821]

Thank you

[@davidscalpscrypto9053]

Not gonna lie I clicked this video because I taught Andrew Tate has a new channel of building things

[@rickyyoung5880]

What’s a

[@erdalgultaslar2527]

Travaille pas propre

[@Aphony66]

Hahahaha, jul boere!