Building a 40 size foam board fuselage.
Рет қаралды 2,781
Күн бұрын
@Twissted-RC 7 ай бұрын
Shaved over a lb off. Has to feel a lot different in flight.
@krvrcreview2722 7 ай бұрын
We will see hopefully the wind calms down this weekend so I can go fly it!
@krvrcreview2722 6 ай бұрын
Its an exact copy of the Tower hobbies late 90s arf just made it a tail dragger.
@daviddavids2884 6 ай бұрын
905 strange wing. apparently, no center section. the vert-stab could be a little taller. should be equal to slightly less-than fifty percent of the horiz-stab span. d
@krvrcreview2722 6 ай бұрын
The wing is the wing that came with the ARF it's balsa wood and plywood.
@daviddavids2884 6 ай бұрын
727 'adding' mass at the tail should be avoided. dom, remember. maybe, glue fillets would do the job, with less mass. obviously, the use of a tail wheel makes the tail Heavier. did you even consider using a (low-mass) skid. 733 there should be NO extra, cosmetic bends in a PUSHROD.! this is not an opinion. d
@krvrcreview2722 6 ай бұрын
Well it flies great and it's balanced perfect but everyone has there opinion.
@daviddavids2884 6 ай бұрын
005 the slope of the vert-stab le is/was excessive. about 75 degrees is nominal. for a miniature vert-stab. there is one problem with making a tail boom from a panel material. it is this: there Will be excess mass in the tail boom, Unless corrective steps are taken.! specifically, construction of the tail boom should accommodate the use of (mass-reducing) cutouts. 150, 915 for a tail dragger, the main lg should be located directly below the wing leading edge. this is not an opinion. for proof, look at full-sized tail draggers. 515 servos go Near the cg, not aft-of it.! this is not an opinion. it's about distribution of mass (dom). similarly, the mass of aileron servos should be located forward-of thirty percent of chord. there is Nothing Wrong with a long pushrod.! assuming it is correctly made/fabricated and installed. conversely, there is 'nothing good' about a short pushrod. 920 the use of full strip ailerons is not recommended, on anything that is not a cropduster.! 924 the root chords of the stabs Should be Equal in length. d
@krvrcreview2722 6 ай бұрын
The only thing I changed on this airplane what is it making it a tail dragger. And building it out of foam everyone seems to be an expert.
Marcel Koch Collections
Рет қаралды 120
Full Stack Woodworking
Рет қаралды 611 М.