Banggood: SCO2 Dual Channel Digital Oscilloscope 50M Sampling Rate 10MHz Analog Bandwidth EN,HU sub

[@ColinMill1]

I became interested (obsessed) by electronics as a kid in the late 1950s. I would have given a few limbs to have something 1% as good as this. There is nothing more useful than a scope for learning about electronics - especially analogue electronics.

[@qzorn4440]

Great Engineer SC02 oscilloscope video. I purchased a SC02 to keep with my op-amp breadboard accessories. It seems to function OK. However, the information is limited and the bzoli5706 video is a great help. 😎 Thank you very much.

[@bzoli5706]

Thank you for your feedback. I'm glad that my video was helpful.

[@bittertruth6575]

Thank you very much for this. I have had this scope for a couple of months now but didn't really know how to get started with it. I'm very new to electronics so this video helps a lot.

[@bzoli5706]

I am very glad that you found my video useful. Thank you very much for your feedback.

[@MrSlipstreem]

Very informative. Thank you. I've just ordered one of these from AliExpress for £30 delivered to the UK. And yes, I did make sure it was the 10MHz version before ordering. 😀👍

[@bzoli5706]

Thank you for your positive feedback. Enjoy your new scope!

[@MightyGimp]

Would you go with this oscilloscope or the Zeeweii DSO154pro?

[@bestchrisspopas4295]

It is the third oscilloscope that I bought, I have digital four channel, small single channel portable DSO150, but I also bought this SCO2, because it is two channel, very useful for the lab at school, because I am an electronics teacher, and it helped me a lot.

[@bzoli5706]

Thank you for your comment. I am an electrical engineer, but I also teach in a technical school. Please look at my video about my Siglent oscilloscope in my classroom.

[@Polibon59]

This is a really helpful video. I bought one of these but haven’t used it much as the manual is so poor. I couldn't figure out how to get it into lissajous mode. Why do manufacturers of such good products let themselves down by not creating proper instructions? Thanks for making this great unit work for me.

[@bzoli5706]

@@Polibon59 Thank you for your positive feedback.

[@LawpickingLocksmith]

Good news for the hobbyist. Hope this will breed new engineers!

[@MbonisiNyathi-q4p]

How do I store wave forms in this oscilloscope and where do I look for them when in need

[@bzoli5706]

Someone asked me to show the inside of the device. Unfortunately, the only way to remove the screen is by heating it, as they do with cell phones. :-(

[@ben12804]

Can you download screenshots from the scope to your computer?

[@zmmmzmmmz]

Would this be good for looking at audio? Seems cheapest 2 channel

[@rv331]

Köszönet a tesztért, nagyon jó lett. Egy kérdésem lenne, a szonda hogyan kalibrálható? A régi oszcilloszkópomnál amikor hozzákapcsoltam a szondát megjelent az 1kHz-es jel és ezután csavarhúzó segítségével tudtam állitani. Üdv.

[@bzoli5706]

Megnéztem, de nincs rajta ilyen kimenet. Talán azért, mert a többség, hogy olcsóbban vegye krokodil csipeszes 1:1 kábeleket kap hozzá. Csinálj vagy szerezz egy jó jelalakú 1kHz körüli négyszöggenerátort és azzal be tudod állítani. A régi szkóp jele is tökéletes.

[@rv331]

@@bzoli5706 Köszönôm a választ!

[@DoctorRevers]

Thank you sir. Very useful. Looks great. Id only be worried about durability. I’ve had a different but similar single channel bought on Amazon that died after a year of light use.

[@drima5035]

Дякую , дуже корисний огляд на SC02 oscilloscope

[@bzoli5706]

Дякую за позитивний відгук, радий, що моє відео було корисним.

[@lomeranger]

I assume this oscilloscope can capture triggered events...?

[@paulcohen1555]

Please make a teardown. It's very important to see which components are used in the input section, A/D and the FPGA.

[@master_codings]

There is no FPGA! MCU GD32F407VET6 + ADC MXT2088

[@paulcohen1555]

I don't think that the Microcontroller can do all the work for a 10MH dual channel DSO. ​@@master_codings

[@master_codings]

i.postimg.cc/d3hzLj7Q/IMG-2264.jpg

[@juanandresblancoantezana7726]

i got this scope and was working great but after some days it now only turns on when plugged. any idea what might the issue be?

[@w4st3lander]

Dead battery possibly

[@kikihun9726]

Frissíteni kéne a szoftverét, sokat csiszoltak rajta. a dobozában volt egy QR kód az oldalhoz. btw simán lejön az előlap egy pici hajszáritó melegítéssel, 4 csavar tartja egyben.

[@bzoli5706]

Köszönöm, ha szétszedted és lefotóztad elküldhetnéd a képet!

[@paulpatrascu7448]

in all descriptions is missing voltage sensibility... 10mv, 20mv...?

[@bzoli5706]

In my opinion, the video is not meant for reading out the technical specifications. That's what the product's linked webpage below the video is for.

[@paulpatrascu7448]

@@bzoli5706 but product web page dont say nothing about vertical sensibility, only current sensibility... that info is missing from web, and if you already have, you can measure his voltage sensibility, but only if you want

[@master_codings]

10mv

[@LeonīdsTkačovs]

Добрый день. Срасибо за обзор. Интересует внутреннее устройство. Заранее спасибо. Здоровья!

[@bzoli5706]

Спасибо за просмотр и отзыв. К сожалению, единственный способ попасть внутрь устройства - снять экран, нагрев его, как это делается на мобильных телефонах.

[@LeonīdsTkačovs]

@@bzoli5706 Спасибо за ответ. Понятно. Ремонтопригодность = 0. Устройство не ремотируемо - одноразовое. Но за такую цену чего хотеть? Я начинающий радиолюбитель в 53 года. 🤓 Выбираю недорогой осциллограф. Предпологаю использовать для безтрансформаторных блоков питания и датчиков автомобиля. Хочу 2 канала и цену до 100€, если сожгу, чтоб не жалко. DSO2512G - 78€: имеет видео выход, но слабые характеристики. У DPOX180H характеристики выше, но цена 122€. И ещё понял, что очень много зависит от щупов, их можно (нужно!) покупать хорошие (дорогие) - они не сгорят... Спасибо Вам за ответ.🤝 Доброго зоровья!👍

[@Valera-x6d]

@@LeonīdsTkačovs Все ремонтируется и греть экран не нужно. Это бред ) Мне пришел прибор с отслоением стекла от корпуса , пришлось разбирать и приклеивать стекло заново. Стекло пластиковое и держится оно на каких то клей соплях )) i.postimg.cc/d3hzLj7Q/IMG-2264.jpg

[@master_codings]

Привет земляки!Китаец закрылся от мира - невозможно с ним связаться! Тот сайт что в инструкции полная лажа там все еще firmware V1.86/V0.6 И нет обратной связи! На том сайте есть ссылка на baidu диск, наблюдаю примерно раз в неделю обновляется дата файла прошивки Там уже V1.98/V0.8 версия.

[@master_codings]

Китаец постоянно допиливает ее. Но скачать с baidu еще та проблема нужен китайский номер для регистрации на сервисе! У меня только европейский. Кто сможет пожалуйста скажите китайщу пусть добавить Аналізатор спектра FFT!!!

[@FelinoAnticomunista]

no image capture to microSD T_T so so so so sad

[@1mouseman]

Thank you sir!

[@JoseLuiz-ql2si]

Aqui no brasil tem o impostinho do amor de 92%~113%

[@trongbangnguyen6706]

good product

[@ohboy4784]

Goulash accent , kusenem 😇

[@uni-byte]

Why don't you remove the film from the screens? It makes them look crappy!

[@bzoli5706]

I am a teacher and I use it in a school, and it gives some extra protection of the screen.