CATIA V5 Tutorial #20 - Assembly design and DMU Kinematics

[@rajanbhandari4828]

Great one, can you upload tutorial for a trolley roller simulation?

[@Mancity9000]

Why planar joint is showing there is more commands not simulated on selecting part2... Have you change the pocket length of that circle??

[@GIRAFLASH2]

Hello, the movable clamp is wrong, it should have a hole that goes through it and on the front another one of the size of the slotted clamp, the threaded hole must have more depth to allow the shaft to come out through the other side of the clamp enough to put the slotted washer and loosen the threaded piece Back off until the shaft is countersunk with the slotted washer.

[@muhammadalisaani1375]

Can ypu share file that how to make this part?

[@anujshukla5470]

Full detailing assembly make description for aeroplane or aircraft.....

[@vinkobosnjak7229]

Do you have documentation. And if you can send me it.

[@navdeepmehta4263]

Can u give me file plzz

[@fachrurrozi2301]

fak