Nice tips with the plastic holder to maintain the filler before tracing and cutting !
@Joe-jv5mm8 күн бұрын
Amazing Talent, Attention to detail, Well worth his Price
@ivanschultz19877 күн бұрын
Классно, очень вдохновляет делать свою работу чуть быстрее, используя ваши приемы и приспособы😊
@jonathanlombard88978 күн бұрын
Skill combined with the right tools 👍
@ГЕННАДИЙ-т2л6ц7 күн бұрын
Товарищ ты крут,дай бог тебе сил здоровья и ума💎
@Supernova0977 күн бұрын
Smashed it! If you read this I have a question: how does your of1400 deal with oak worktops? Is it powerful enough and how many passes do you tend to take for the joins? Thanks!!
@josephmasini64887 күн бұрын
Beautiful work.
@dougieranger8 күн бұрын
Excellent work as always mate.
@FranklinIsrael8 күн бұрын
Absolutely beautiful
@ramiabuyaqub12587 күн бұрын
Wonderful Job
@sborshik_semenov6 күн бұрын
good👏
@franciscoducival96018 күн бұрын
🇧🇷 Boa tarde meu professor! Abraços cara, vc é o cara.
@Matthew-r2u8 күн бұрын
Hi I've watched lots of your videos. Regarding scribing of the fillers. I see you use a compass in many videos. I have tried it. And then try my best to cut and plane to the line. But I can not get it perfectly. It's likely just a matter of practice. But cutting to the line or cutting the line completely is one thing I am unsure about. I've tried many times. I have begun even to think that the uscribe I bought from eBay, a cheaper 3d printed model may be the cause as perhaps it doesn't 90 degrees the pieces when I attach.
@raminybhatti57408 күн бұрын
Beautiful
@jackylim13308 күн бұрын
Fantastic ~~
@lesleywillis61777 күн бұрын
I made one of them once. Couldn’t stand it up as the ceiling was too low!😂. Had to take it to pieces again.
@zachlehkyi99518 күн бұрын
Building cabinets on site sucks so bad. I try to avoid as much as I can. Sometimes you have to modify and basically rebuild them but man I feel your pain trying to put big boxes together in a tiny room. Even worse when there’s no power
@console.8863 күн бұрын
Why do you put separate modules with drawers inside and not make it on the main ones?
@vyacheslav_chkhaidze8 күн бұрын
✌🏻👍🏻🔥
@ovyarad8 күн бұрын
Link sablon handle. Thanks. 😊
@DIZAYN075 күн бұрын
Tebrikler
@FranklinIsrael8 күн бұрын
Awesome tools. Those tools would have cost a fortune
@MafiuMafiu3 күн бұрын
DIY ? Not everyone has tools around $10k, I have a hamer and nails, how can I do same?
@peterleishman4318 күн бұрын
Did you make all the panels
@jaka25277 күн бұрын
With that mustache you look like a musketeer👍
@Preston_Ryan2 күн бұрын
Everything is from Festool, but the "Domino" is a fake-one... Why???