CDSU Tool ELGS-BS (Data Restore Active) Replacement with Parameterized EMCS-YY-ST-42

This video describes how to update an un-parameterized (EMCS-YY-ST-xx) motor with a parameter set of a SMS (Simplified Motion Series) device being replaced
(0:01) Overview
(0:40) Festo website ELGS-BS file downloads
(4:32) Festo website EMCS-YY-ST-xx file downloads
(6:10) Festo website CDSU-1 IO-Link Master software download
(6:40) CDSU Tool software - Connect to SMS (Simplified Motion Series) device that will be replaced to determine parameter values
(7:05) CDSU Tool software - No IODD files exist in software and how to register
(8:04) CDSU Tool software - Determine Parameter Value for End Position “Out” for SMS (Simplified Motion Series) device that will be replaced to determine parameter values
(8:36) CDSU Tool software - Connect to EMCS-YY-ST-42 Un-Parameterized Motor
(9:23) CDSU Tool software - Open parameter file for the SMS (Simplified Motion Series) device that will be replaced
(10:06) CDSU Tool software - Update the SMS (Simplified Motion Series) device that will be replaced with the opened parameter file.
(10:43) CDSU Tool software - Parameter update is successful - Device will now be recognized as the new device type
(11:09) CDSU Tool software - Encounter error message "Parameter package download error - parameter set incompatible" then open the Specialist (user role) and click the "Store Parameters" button.
(11:40) CDSU Tool software - Cycle LOGIC voltage and the Error should now be cleared
(11:57) CDSU Tool software - Specialist (user role) tab - Execute "Reference" movement.
(14:31) Describe what to expect when replacing with/without data storage and show an example using Data Storage (Restore Only) active.
(15:52) Describe list of implemented Data Storage parameters
(18:21) If Data Storage (Restore Only) is active in the device being replaced, be aware that the value of End Position "Out" (set through a reference run) in the replacement EMCS-YY-ST-42 (parameterized as ELGS-BS) must be greater than the maximum value stored in the IO-Link Master, otherwise the value will be discarded and a fault will be present which can only be cleared by Disabling Data Storage.