Change Spare Parts in FC 5 || How to repair Karcher FC 5

[@whuzzzup]

Good video. In case anyone has a problem with the roller being stuck, it's because Kärcher put in some cheap ball bearings that rust shut. You can buy stainless steel ball bearings (6803RS2). Unfortunately you basically have to take the whole thing apart to reach them. 30 screws...

[@Rahulkpw]

If you have any issue with product, please call on 18001234180

[@MegaChickenPunch]

you need 4 new bearings: two 6803 2RS two 627 7x22x7

[@mrtankalotrctankschannel]

Thanks so much, just fixed mine watching your tutorial, excellent!

[@linocatube]

Very very good !!!!!

[@yimenici]

Thank you so much for the video and your efforts.. I kindly want to ask you; clean water doesn’t come out from our machine’s water tank, is there a pump motor for it.? What is the problem can be .?

[@yimenici]

5:59 i need a that part.. I stuck the power cable between brush and that knife, then thet plastic knife has been sheered..

[@yimenici]

And one more question, I got changed the knife two times because of cable is stuck into brush and knife.. Can I change the knife by myself.? Which parts do I need to buy for replace the knife.?

[@SpikesMavic]

Gread vid , what size was the Torx screwdriverfor the smaller screws, I know T15 is for the larger screws .

[@Rahulkpw]

T9 is a screwdriver.

[@SpikesMavic]

Who has mentioned T9 ?

[@Rahulkpw]

@@SpikesMavic it's me.

[@SpikesMavic]

@@Rahulkpw Sorry , got it now it is a flat screwdriver and a T9.tks

[@junaidyousuf3978]

Where i can find the roller part my rollers are not moving and how much it cost?

[@Rahulkpw]

Please contact on 18001234180

[@MrPilsen1975]

Do you have the parts numbers list?

[@Rahulkpw]

Which part you require ?

[@robertobaggio5522]

No water coming out,how ti fix It please?

[@Rahulkpw]

Hi Thank you..! First you need to clean roller yellow flap, see the waste water filter, check ther fresh water 💦 filter position.

[@robertobaggio5522]

@@Rahulkpw i did it i did everything to clean but no water coming out

[@yimenici]

@roberto baggio the same problem I confronted, have you figured out the problem.? If so; How you did that .? Thank you..

[@robertobaggio5522]

@@yimenici si ho fatto un buchetto col trapano alla base grigia e ho messo dentro un po' di wd 40

[@SanSanich]

Вода не течёт потому что шланг передавлен кнопкой для снятия насадки. Там не хватает пружины. Этот момент в видео упущение. На кнопке есть посадочное место под пружину. Это тоже видно на видео. Когда ставите насадку их за отсутствия пружины кнопка не поднята и шланг передавлен остаётся.