Well this took some effort and I was huffing and puffing a bit, but it is satisfying to do a job like this in my own garage.
Пікірлер: 7
@zakzhango24958 күн бұрын
You were struggling to fit the tyre because you started at the wrong place. You should start opposite the valve and this lets you keep the beads into the well of the rim so the centre point of the tyre is offset to the centre point of the wheel. You finish at the valve. Also, why not get a tub of proper tyre soap? You mentioned that there is water inside the rim and this can lead to corrosion.
@bluesriderDF8 күн бұрын
I've learned a lot since doing this one. I'll be doing another over winter, I expect to be better at it.
@zakzhango24957 күн бұрын
@@bluesriderDF That's good to hear and I encourage anyone to learn how to fit their own tyres. It's about technique and not skill.
@tedjackson6300 Жыл бұрын
I was taught to deflate the tire after it seats and bounce it on the floor while turning it to remove the wrinkles from the tube. Repeat this process three or four times and you will have no wrinkles or folds in the tube. Good video, Thanks