Today I will show you how to replace a nissan qashqai boot handle.
Пікірлер: 25
@theeditorgareth6 жыл бұрын
Shame you missed out the most important bit - how to put the handle back onto the retaining bolts!
@simonduffy996 жыл бұрын
Try this video for a very neat repair. kzbin.info/www/bejne/bZzPf5KZnb5gaac
@richardturbine17692 жыл бұрын
These panel handles are a very silly design, being plastic, the back door is heavy and hence these are bound to break - they should have been made of metal, or, at least have a large metal strip inside for fixings.
@sonicwingnutАй бұрын
Christ so I have to remove the whole back panel? Oh well, just a shame mine looks nothing like that! Good old cars swapping round parts..
@simonduffy996 жыл бұрын
Try this video for a very neat repair of this problem. kzbin.info/www/bejne/bZzPf5KZnb5gaac
@kevinh94186 жыл бұрын
Not very helpful. Seemed to be missing about 50% of the instructions.
@MICHAELANDDEREK5 жыл бұрын
What a waste of time they missed the most important part of the fixing!!! Crap!!!
@livhuananiramala72584 жыл бұрын
Thanks, can you help me with the name the boot switch
@dm91932 жыл бұрын
Waste of time video… reassembling the handle is missing 😂…
@sometimesinaugust8 ай бұрын
Thanks brother!
@dashcamdude66906 жыл бұрын
how do you put back the cover back ?
@NeilHames6 жыл бұрын
I watched this as I also need to fix my tailgate handle assembly as the plastic holders have gone brittle over time and failed - a very common problem I am learning due to a design fault using an inferior plastic for something that takes a lot of strain. I believe you can only fix this by replacing the whole assembly?
@simonduffy996 жыл бұрын
Try this video, if you haven't already paid for a new one. kzbin.info/www/bejne/bZzPf5KZnb5gaac
@johnmacleod-j8z3 ай бұрын
You dont need to replace the whole lift plate, as there is a repair kit for aprx £15 that nissan dont tell you about.
@elliewallace6943 жыл бұрын
pl
@timdixo6 жыл бұрын
Murphy's law,the CRITICAL part of putting the tailgate cover back on was missed.....grrrrrrrrr!!!!
@dhalsim-15 жыл бұрын
Hooooooooowwwwww did you clip the handle back on?
@izaksmechanics5 жыл бұрын
dhalsim1 Hi there if you are Changing the handle sometimes the handle comes with the screws which is already fitted onto the handle if not you have to take them off the old one and put it on the new one then put it back onto the boot and tighten with the bolts
@dhalsim-15 жыл бұрын
@@izaksmechanics Thanks
@raspizo5 жыл бұрын
good job
@malexandruro6 жыл бұрын
Nice job. What kind of adhesive did you used to glue the bolts? Thanks
@bladerunnersn6 жыл бұрын
malexandruro dont think they need gluing
@malexandruro6 жыл бұрын
but then what's that grey/silver material around the base of the bolts? cause in my case all the plastic pieces that hold the bolts are broken...