Changing Peco point springs

Changing Peco point springs

[@riogrande5761]

I have Peco code 100 Electrofrog turnouts and the spring assembly doesn't look like either of these. I'll put it on hold until i can figure it out.

[@seanmyles2893]

Thanks for this, very instructive.

[@sammym.belfastchild]

@Patrick Nicholls , is this the same for N scale Peco turnouts too. Cheers , Thank you For sharing this with us.

[@ewoodrailway]

Very good how to video. I have Hornby points which don’t quite stay in place, do I need to change the springs ?

[@ratp78]

Unfortunately I find the Hornby springs almost impossible to change as there are very small plastic pins holding the spring covers on that break as soon as you try to remove them.

[@LeoStarrenburg]

Thank you 👍 !

[@peacemeal3196]

Awesome- thanks

[@goodisonroadmodelrailway6798]

Thank you worked well Is it easy to replace moving tie bars I have 2 points with broken upright knobs? Cheers JC

[@busboymk2]

Thanks for uploading this video, that's saved me hours of digging points out of the ballast ! 👍👍👍👍

[@jimsmoter4510]

Usually the spring is removed if a switch machine is being used ..

[@westwonic]

Nice job. Very useful video

[@TheAudiostud]

Great work, Well Done

[@fjrboy]

Nice one..

[@graemehancocks4171]

Thank you for this 🙏. Was able to repair a broken point following this - wouldn’t have had a clue otherwise!