Chevy Silverado GMC Sierra ball joint replacement- 2014 and up

[@dabofiron.itzsimplicity]

Thanks a ton dude. One of the best videos regarding automotive repair I’ve seen in a while. Short, sweet, to the point, everything I needed to know. You, sir, are a god among men.

[@robguysgarage5422]

Thanks man, really appreciate that!

[@robertnevarez7599]

Amazing work brother!

[@robguysgarage5422]

Thanks! hope it helped

[@majordog85]

Thanks my brother for taking the time to show, you got yourself a new subscriber 🎉

[@robguysgarage5422]

Awesome glad it helped, thanks

[@maddawglynn]

Sweet video man. Thanks!

[@robguysgarage5422]

Thanks for watching!

[@knightryderbelow]

Awesome job! Thanks for telling us the bolt sizing and torque ratings.

[@robguysgarage5422]

Thanks for watching, I try to give the sizes and torque for all the repair videos I do

[@veeneecee3341]

Good video, I’ll be doing this in a few days. Thanks.

[@robguysgarage5422]

Glad it helped !

[@coltonwatt423]

Thank you so much for the torque specs!!

[@robguysgarage5422]

glad it helped

[@adewey33]

Is there a video for a 2WD rear. My 2014 Chevy suburban a lower ball joint replacement in the front wheels.

[@robguysgarage5422]

I would think it would be pretty much the same procedure only easier since you don't have the front axle shaft to deal with, I looked up the part numbers and they are different, but the ball joints look very similar so it should be the same basic procedure as mine, thanks for watching

[@adewey33]

@@robguysgarage5422 thank you Sir!

[@dgyk-xggl1047]

thanks its a helpful video

[@robguysgarage5422]

glad it helps, thanks for watching

[@nicolasgabriel7033]

Nr de parts ???

[@robguysgarage5422]

Moog K500245

[@brentdavenport4214]

Unnecessary to remove wheel bearing from knuckle. Just caused more work for yourself. Just remove the knuckle as one unit.

[@robguysgarage5422]

true, didn't know at the time if there would be enough space to get it out with the bearing in there

[@brndngvns69]

It was all good until you smacked the wheel bearing with a hammer. I assumed you were replacing it. You'll be doing the work again soon

[@robguysgarage5422]

We'll see, if it does I'll make a video on it

[@mikecopenhaver4484]

125k+- you will replace wheel bearing, should have while it was all apart! Other than that pretty basic,good job.

[@robguysgarage5422]

Thanks!

[@devilishirv]

i would assume its easier on a 2wd 😂

[@robguysgarage5422]

It certainly should be