Christmas Repair Special - Weller WES51 Soldering Station

[@redstrawberry667]

Do you have a part number for the BUSS 125V 4A fuse? Or will really any 4A though hole/axial work for that?

[@CelGenStudios]

I do not have it handy. :/

[@jeyakrishnansethu1848]

Well done I did really enjoyed and can you bring up more videos thanks and if I need any services from you for mine weller how is the way I want connect you thanks

[@sodacrazy1]

Hey, I have one of these and the knob is off. Do you think that I can fix it somehow? I do some repairs, but I'm not great. I found your video, and you seem to know what you're doing, so here I am. Any help would be appreciated. Thanks Julie

[@CelGenStudios]

The bits that hold the knob in I've had fall out before. I just found a suitable small screw and used that to hold it in.

[@sodacrazy1]

@@CelGenStudios Thank you! I wasn't sure if it was connected to something else. I was hoping this was the case! Thanks again!

[@freestyla101]

I discovered a short in the iron the hard way by popping this stupid non-serviceable fuse. I gather from comments that it’s a 125v component but we use 240v where I am. Would I just use a 240v 4a fuse?

[@CelGenStudios]

I think in this application it should be fine.

[@kovaliktube]

I have the same station and it's still going well but the the plug for the iron is loose and I can't disconnect the iron. Have you seen that problem before?

[@CelGenStudios]

Nope. That's a new one for me.

[@mikelemon1147]

Will the LED light up if station is switched on but the soldering iron (pen) not plugged in ?

[@CelGenStudios]

I don't actually remember checking that. I do know a wand with an open heater will turn the light on but obviously it will never heat up.

[@freestyla101]

I know this is old, but in case you’re still wondering it won’t

[@davidchavarria]

question i have the same one. is it possible to design it to have a digital screen?

[@CelGenStudios]

No idea, sorry.

[@L337g4m3r]

Damn, they made the fuse holder too small to put a penny in it... (Why wouldn't they make this easier to get at though, seems like a pain.)

[@GottaKnowJoeHobbies]

Dont want to wish bad luck but darn I need more help deeper Good pencil fuses and caps good but knowledge stops there

[@Stjaernljus]

2:28

[@CelGenStudios]

I need like elevator music or something beyond a cheesy test pattern. Thank you.