Cisco CCIE R&S - VACLs and PACLs

[@Mongoosemcqueen]

Anthony Sequeira is the GOAT Cisco instructor

[@AnthonySequeira15626]

So sorry I missed these comments back when I had no idea what I was doing on KZbin. Thank you for watching and commenting!

[@renznan]

it seems that Telneting form to R1 to R5 will not be passing thru Switch3 (where the VACL was applied). So, no VACL applied at Switch1 it can be Telnetable.

[@AnthonySequeira15626]

Are you still active here - did you want me to look at something for you? So sorry I am just now seeing this…..

[@mohammadsaeb9576]

THANK YOU SO SO SO MUCH

[@AnthonySequeira15626]

Thank you for watching and commenting!

[@bcs9581]

Referring to VACL, the traffic from R3 to R5 seems to match in the acl. then why didnt the corresponding dropping action is not taken by the switch? Is it because R5 exist in another VLAN?

[@bcs9581]

@@AnthonySequeira15626 Thank you sir

[@AnthonySequeira15626]

So sorry I missed these comments back when I had no idea what I was doing on KZbin. Thank you for watching and commenting!

[@AnthonySequeira15626]

Hope you are well after all of these years.

[@m0rphe0-8]

Why NOt work in gns3 ?? _I use SW IOU , Sw IOSV

[@basadake]

gns3 is free, but u cant get a legal ios image for free. maybe thats the reason.

[@AnthonySequeira15626]

This will not work in GNS3 as VACLS are a layer 2 construct and the Layer 2 is very difficult to emulate in GNS3. It has a much easier time with Layer 3.