Civil 3D and SSA Workflow - Storm Water Inlet and Pipe Design Workflow

[@christiangodino8420]

thank you for all your video, i learned a lot. this is a great resource for this topic.

[@awdarda]

Thank you for your great video.Was looking for this for long time. Very helpful. I learnt a lot.

[@dojovaco]

Nice, thank you.

[@evanrambikur1708]

This was very informative for me, thank you. Is it possible to define the gutter data within Civil 3D or only within SSA? Is it possible to do a partial import or update of the existing model into SSA? Thank you.

[@ckong676]

good job

[@johnsayre4827]

When I did the video, keep in mind I am showing functionality of the software and I was not necessarily concerned with the design. I apologize, I was not focused on teaching design necessarily. Does that make sense?

[@2003ximba]

Thank you Sir

[@sakhumzitima3213]

Hi John, thanks for these videos I visit them whenever I get stuck, but I wanted to ask if it is possible for SSA to automatically optimize and change to adequate pipe size.

[@peterlee7985]

how did you get all the label be staggered automatically? check video time 6:09

[@tyeasmin]

Hi John, I am one of your fan and learn a lot from your videos. I am facing a trouble in SSA and hoping to get a little help from you. I have a EPA SWMM model and I want to import it in SSA for further improvement. But by doing that the inverts are offset exactly the inverts number of the pipe. For example if a pipe has inlet invert is 350m and outlet invert is 351m, after importing the network in SSA these inverts are just going up double (imported inlet invert = 350+350= 700m and outlet invert = 351+351=702m), which is not right. Would you know what am I doing wrong here? I appreciate your time and help.

[@thusithaamarasinghe7824]

Can you please explain the design of the vertical pipe using SSA?

[@marcelinodiaz8133]

Hello John, where can you get the IDF curve table files?

[@marc07112]

How do you do a bypass link in a field, say like an airport infield area? Direct or gutter? Or do you just say the lateral pipe leading into the trunk line?

[@johnsayre4827]

I would probably try a direct link.

[@2003ximba]

When you add the "gutter" for bypass flow, we do not have to worry about the length and inverts of the gutter function?

[@johnsayre4827]

Correct.

[@2003ximba]

Thank you Sir

[@Splishsplashin]

@@johnsayre4827 Why do we not need to worry. Are these values not used in the bypass flow calculation?

[@karabusch2841]

Anyone know how do you reverse flow direction in version 13.4.133.0?

[@andrewsamuda3266]

Great video. What was your simulation period and how did you select it

[@castled71049]

After setting up SSA and run the analysis, I get the error message "INF is not a valid floating point number." Any idea how to fix this problem? Thank you.

[@abdullahn9827]

it provides the error number. Get that and look in help manual, you will know whats the error

[@benzonjhermogeno]

Difficult to use the software